Questions and plumbing advice in the Bathrooms, Showers and Wetrooms - .
Some popular plumbing forums: Plumbing Advice - Plumbing Tools - Plumbing Courses & NVQ's
Hi, I need a Beta Cistern Washer for an old 1930's Armitage Shanks Toilet. Nobody has one. Can someone help. Or know anywhere that I might get it ? Any help much appreciated.. Hazel...
Hi, I have a tap in my bathroom which has a slow drip leak. I can't figure out how to disassemble the tap. I think it is a John Sydney model and is about 15 years old but that's all the info I have about it. I've attached a picture of the tap.
Any ideas about how to disassemble it?
Thanks.
Hi, does anyone have any advice on fitting a natural stone resin bath and shower trays over wet UFH. I have been advised that the bath could be in danger or cracking if the UFH runs above 35 degrees but this is probably not going to be the temperature needed to keep the house warm as it is the...
Hi all
how do you remove these smart sleeve inserts from an HEP 2.0 pipe
thanks
Long time listener, first time caller.
I am finishing my basement but the one area I lack confidence is plumbing. I am looking to verify if what I have planned is acceptable. Framing is complete - The bathroom wall shares a wall with a wet bar on the other side.
I have a 2" stack coming...
I have a dripping bath tap. Seperate to the spout. Quarter turn level tap from the wall.
I need to change the cartridge as it’s dripping lots but can’t seem to work out how to remove the housing. Has this been installed badly behind the tiles?
Hi,
Just had a new bathroom fitted and have a pathetic flow of hot water from the sink tap. It wasn't great before. I can't get hold of a plumber, but any ideas as to what this might be? I also noticed that the pipes that feed the hot tap go into the loft? I know nothing about plumbing, but is...
Hi, all.
Advice required. I want to install an En-suite toilet and wash basin. It's in a guest room and will only see occasional use. There's no room for a shower pan, but I can squeeze in one of those combined basin and toilet units.
My question is - can I install a toilet and basin where...
Our master bath shower had two shower heads. One was leaking/dripping so our plumber changed both cartridges since he was already there. That fixed the leak, but ever since one side gets too hot and the other side only stays hot for 5 minutes before slowly getting colder and colder. Our plumber...
hi all
i need some help and advice
i am tiling around 2 shower pipe fittings. as the measurements were intricate i was practicing on off cuts and trying to create a template. I've noticed when i drill holes into the tiles sometimes they would crack. i don't use any pressure or drill too fast...
Hi. I have a Vado summit bath tap with hand diverter. Recently the diverter stopped working and after liaising with Vado, I managed to remove it. When I removed it , it appeared that the O ring had come off the diverter and when placed back , it works fine. My question is that please can...
Hi. I'm currently estimating on installing a new shower pump to feed an existing bath/shower diverter.
Hot side: fit flange and spherical valve and Y strainer to old cylinder, reduce to 15 mm and to pump flexi and reconnect existing hot distributing pipe.
Repair shelf in AC and fit twin...
Hi we have a rainfall/riser shower fitted over the bath, on a agravity fed system. We have 2 showerboosterpumps under the bath which supply the hot water in the kitchen below and the bathroom hot water. The problem is the shower won't kick in when turned on, pressure is good on all other taps
I am just finishing a new build with Panasonic heat pump and several bathrooms.
the main bathroom has a Mylife Desire concealed shower with triple controls.For some reason the tiler built the tiles out further than the 20mm agreed so the shrouds are flush with the tiles instead of protruding...
Hi Guys
I am at the design stage of having a En-Suite built and have an issue that I cannot seem to resolve.
For long and complex reasons I have to have a macerator and that needs to sit behind a close coupled toilet.
this will take the waste from a sink, shower and toilet.
Saniflow say I need...
Grudfos do a unit called Sololift WC3 that has a recessed front that suggests it might fit behind better but as I cannot get to speak to anyone at Grundfos other than an automated messaging system, I cannot confirm this.
So my question is, have any plumbers on the forum had issues fitting...
Hi,my shower is very slow draining.the trap is clear of hair/debris,any idea of what could be the problem?
I'm looking for deck-mounted taps for a low-to-medium head. Access once installed will be near impossible so the taps ned to be reliable. Recommendaitons and "avoid at all cost" advice appreciated.
John
Hi,
I am looking for an sink that can replace an Crane Bathroom sink (oval) I think is an 17*20 but I am not sure (what is the standard size ?)
also I don’t want something cheap.
Hi all,
This shower valve is about 20 years old. Can anyone with a bit more experience than me identify the brand/model? No markings visible. Distance between centre of valves: 70mm
Thanks in advance
Creating content since 2001. Untold Media.
Tags
Newest Plumbing Threads
-
Trying to source a dual-flush valve
- Started by Thomas J Marshall
- Replies: 2
-
-
-
-
What constitutes a Commercial Appliance and thus a Commercial Kitchen?
- Started by FozzieBear
- Replies: 3
-
POTTERTON PROMAX 28 COMBI Boiler - Hot Water Issue
- Started by boiler101
- Replies: 4
-
Hole in copper pipe, solder under floor, T coupling & protection- Started by dreikher
- Replies: 0
-
-
-
-
-
-
-
-