Search the forum,

Discuss Im in the Philippines, so my products are limitless in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Messages
2
Hi all



OK my problem is this.
I have NO water supply to the sink in my shop.
So I can fill a water butt everyday and connect to a kitchen sink tap.
I will either use a submersible pump or stand alone (like a grundfos) pump to pump water from butt to the tap.
My problem lies in If I use a flow switch to on/off the pump when the tap is turned on/off
when turning the tap on for the first time, will the flow switch tell the pump to come on?
Because there will be no flow to the tap unless the pump is on?
And water is gonna be flowing up hill so I can use gravity effect to start the flow
 
Go for a negative head pump, senses the loss in pressure rather than flow through the pump
 
there has to be a permanent electric power supply
 
Status
Not open for further replies.

Reply to Im in the Philippines, so my products are limitless in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

I have a problem with noise and vibrations from my shower when i first turn it on. The problem lasts for about 30 seconds after the shower is switched on before it stops. There is a sink nearby, sometimes if we switch that on slowly before turning on the shower then the shower doesn't make a...
Replies
0
Views
305
My central heating is run off a heat pump ( air to water ) quite expensive to run , So I’m plainning to fit a wood burning with a back boiler to connect to the heating system, So while the wood burning on during winter months it will stop the heat pump for working hard Or not all all . My...
Replies
3
Views
235
Hi, I'm in my new build 2 years and the shower pump has died. I have an air to water unit downstairs is in the utility which I've been told is unvented and pressurised. The cold water feed into this cylinder is from the attic tank, not the mains as I turned off the mains stopcock to see if hot...
Replies
6
Views
160
Hello, I have quite low flow rate for my electric shower (a piddling 5L/min), and would like some tips or advice about how to solve or find the cause. I would like a flow rate of about 12L/min. Here is my set-up: Standard gas boiler (not a combi) in the kitchen, have cold water tanks in the...
Replies
14
Views
806
Essaboy
E
Hello All, I wonder if you can help me? I have intermittent hot water low flow from all taps in my 4 bedroom house upstairs and downstairs. I can sometimes recover the usual water pressure by turning the hot and cold water taps on and off which seems very strange to me. There is no problem...
Replies
3
Views
308
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock