Search the forum,

Discuss Tpcp1 and 1a how hard are they ? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Messages
6
Doing them both on Wednesday can someone tell me what it's like please never done it before.

Thanks
 
Doing them both on Wednesday can someone tell me what it's like please never done it before.

Thanks

I find it OK but I've always had Commercial/Industrial.
More calcs, more thought, no generalising really, each installation taken on its own merits!
 
How are you on math

If your good with it you will fly through it most of the ones when I resit struggle with maths and they fined it hard
 
Are you doing Pre training and Assessment or just straight into Assessment?
Have you done/seen any real life work on it?
 
I have done it 4 times you need to do the training and be good at maths, glad i dont have to do it anymore ha ha good luck though. Kop
 
Status
Not open for further replies.

Reply to Tpcp1 and 1a how hard are they ? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Recently had a Viessmann Vitodens combi boiler installed, quite often when the adjacent cold mixer tap is opened the boiler starts for a few seconds! Can anyone tell me what is causing this? And how to cure?
Replies
3
Views
183
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
174
Hi, My current hot water system needs to be replaced. Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off? An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au. How reliable is this...
Replies
6
Views
232
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
120
Hi guys. I'm trying to identify a toilet model before ordering a seat for a customer. I went to what used to be a Roca stockist (they no longer are) and one of the guys there reckoned it might be "The Gap". I went to the new stockist and the guy there disagreed it was "The Gap" and that he'd...
Replies
2
Views
118
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock