Search the forum,

Need to source some valved domestic brass manifolds .

Discuss Need to source some valved domestic brass manifolds . in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
king of pipes

king of pipes

Esteemed
Plumber
Gas Engineer
Subscribed
Messages
6,157
As above need make up 2 - 12way valved manifolds for a project but its proving expensive anyone know of a supplier ? Regards kop.
 
hot and cold? or heating?
 
Hot and cold shaun , made the heating ones up with copper tees scott but its all top end showers counter top basins wall mount taps fancy units so need isolation.
Cheers kop
 
They look ideal shaun thanks mate 24 15mm levers comes out at Ā£153 bit much so hopefully these will work . cheers kop
 
Status
Not open for further replies.

Reply to Need to source some valved domestic brass manifolds . in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

J
Leak detection company
Does anyone know a good, not super expensive, leak detection company in the London area?
Replies
0
Views
279
John-sjw
J
C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
0
Views
116
ChrisGid
C
B
What is correct toilet supply line
Hi. I need a new toilet supply line but donā€™t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic nut about the same size as the one going into the cistern but has a different thread. Attached is a photo. Can you advise. Thanks.
Replies
2
Views
167
ShaunCorbs
ShaunCorbs
T
22mm MDPE connection
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it šŸ˜¬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Replies
1
Views
219
ShaunCorbs
ShaunCorbs
A
copper vs pushfit pipes
Copper pipes, I think its fair to say, is not what it used to be, the copper is getting thin while the cost is going up. Meanwhile, plastic Pushfit seems to be getting better and better, cost and convenience was always better, but now the quality is to, have we reached a stage where plastic will...
Replies
2
Views
180
Chuck
C
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock