Search the forum,

Recent content by Rightjob1

  1. R

    Speed fit reducer disaster

    Iv had the same issue with copper olives onto brass reducers. I always put a piece of pipe in now
  2. R

    Accumulator expense woes

    Fit a grundfos scala 2,i fitted a Dab e.sybox before and was not too impressed with the noise from it. Performance was pretty good though.
  3. R

    Water pressure drops when neighbour's use theirs... At my wit's end!

    Must all be fed off the one mains,And when someone else uses a mains fed outlet yours is last on the line. You can avoid it by using a tank and then pumping into your combi
  4. R

    Water pressure drops when neighbour's use theirs... At my wit's end!

    Sounds like poor mains pressure,does ewch property have its own mains?could be shared.. You could solve it by using a break tank and then feed into a pump to pressurise all your outlets.
  5. R

    Lukewarm 'hot' water - secondary heat exchanger already changed

    Did you turn the valves off to the tap as in turn the colds off and run the hot only..this will tell if there is a problem in a fixture of cold crossing into hot
  6. R

    Lukewarm 'hot' water - secondary heat exchanger already changed

    Turn off all your colds to fixtures in the house and run the hot on its own..if it works fine then you have a tap that mixing tthr hot and cold
  7. R

    Constant air in central heating system

    Zone valves and a solid fuel boiler stove?!
  8. R

    New cistern leaking into pan

    I would not accept that for a fix!it should work properly from new from the factory,and if they cant make that happen without adding putting i would want a new one or change of brand.
  9. R

    gravity system, loud noises

    This worked even with your automatic by pass in already?
  10. R

    gravity system, loud noises

    Did you keep the same flow and returns of new and old?
  11. R

    One radiator not heating up - too many close pipe turns?

    Some of those rads have specific flow and return sides. What model rad is it?
  12. R

    Glowworm 24ci , no display on interface board

    Are you gas safe registered? I take it you are not if you called an engineer out already
  13. R

    New cistern leaking into pan

    The silver flexi that you show in the photo on the left hand side,follow that flexi back to the right hand side and take a photo
  14. R

    New cistern leaking into pan

    only thing if can be is the syphon isnt sealing properly and allowing water to pass into the pan or else the water level too high in the cistern and its overflowing into the pan!
  15. R

    Worchester Bosch error code EA - Part 2

    Also if you had been GSR theres a very high chance you would have known the fault without half of the dangerous messing you done before hand
Creating content since 2001. Untold Media.

OFFICIAL SPONSORS

OFFICIAL SPONSORS

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock