Search the forum,

Discuss Gas Safe Engineers in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
My mother has got a problem with her boiler its sounds like there's something turning around in the in side of it and sounds like this tick tick tick when its turning does it sound something major thanks
 
Hi chaps, has anyone come across a boiler installation in one property but the flue termination in next doors property, i don't mean terminates across a boundary i mean the whole boiler flue is across the fence in another property
 
Hi chaps, has anyone come across a boiler installation in one property but the flue termination in next doors property, i don't mean terminates across a boundary i mean the whole boiler flue is across the fence in another property
 
you would think so , but the building inside goes beyond the boundary and the boiler is in a cupboard which is on the other side of the fence, very strange.in my estimation this is a no no and would have to be rectified as the fence boundary can't be moved. any thoughts
 
they'd be made to move it if neighbor complained and building control got wind i would have thought. not sure its particularly actionable if not.
 
so i would imagine its more of a building regs situation than a gas safe one ?
 
hi croppie i have sent my photos off the back and front of my card but i have not heard from yourselfes as yet ? is this done ones a month whating two be reconized told you about the spalling before sorry
 
Both forums confuse me but then again I'm new to all this. I'm up for anything that lets me tell them apart.
 
Please be very aware that this is an open forum.

Please take ALL gas related threads where you are discussing the technical and safety related repair of boilers into the Gas Safe Registered Engineers Sub Forum!

Thank you!
would be nice to find this gas safe forum;)
 
Status
Not open for further replies.

Reply to Gas Safe Engineers in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is a 23.8Kw appliance with all six burners and oven on max. This was installed some 10 years ago and has passed all subsequent Gas Safety inspections as...
Replies
4
Views
368
We are from Alberta, and I own an electrical company. I have been asked by a BC Mechanical P. Eng. to install an emergency STOP button at the man-door to the boiler room. It's intent is to 'halt' the operation of the boilers in the room should there be an emergency. He is demanding that I do...
Replies
5
Views
228
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
0
Views
53
Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended floor. Pic 1 is inside porch, pex temporarily clipped to give an idea of pipe placement (ignore shoddy blockwork of booted cowboy builder!), Pic 2 is...
Replies
6
Views
217
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
168
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock