Discuss What model of Vaillant is this boiler? in the Plumbing Jobs | The Job-board area at PlumbersForums.net
- Status
Looks like a Turbomax Plus 824E / 828E / 837E to me. Only 83% confident though.
- Messages
- 967
Is there a sticker underneath on the casing near the valves?
Nope - no sticker.
- Messages
- 10,444
I'm sure that the Turbomax had green buttons, looks more like the original ecotec which I believe was an ecomax. What size property is it. Think they did an 824 & 828
I believe that green controls were 'refreshed' with white ones after a year or two, which made them look better IMO. This website has photos of lots of Valliants:
Vaillant Turbomax Plus Pro Technical Help and Customer Advice
There's one of a Ecotec, which does look very similar but had "Ecotec" branding on the front.
- Messages
- 6,131
- Status
Reply to What model of Vaillant is this boiler? in the Plumbing Jobs | The Job-board area at PlumbersForums.net
Similar plumbing topics
Hi guys. I'm trying to identify a toilet model before ordering a seat for a customer. I went to what used to be a Roca stockist (they no longer are) and one of the guys there reckoned it might be "The Gap". I went to the new stockist and the guy there disagreed it was "The Gap" and that he'd...
Recently had a Viessmann Vitodens combi boiler installed, quite often when the adjacent cold mixer tap is opened the boiler starts for a few seconds!
Can anyone tell me what is causing this?
And how to cure?
Does anyone know a good, not super expensive, leak detection company in the London area?
Hi all
Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my toilet a good few times nothing is going to the sewer so don't know is there a blockage or what way it works many thanks and advice would be grateful
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic nut about the same size as the one going into the cistern but has a different thread. Attached is a photo. Can you advise. Thanks.
Creating content since 2001. Untold Media.
Newest Plumbing Threads
-
Trying to source a dual-flush valve
- Started by Thomas J Marshall
- Replies: 2
-
-
-
-
What constitutes a Commercial Appliance and thus a Commercial Kitchen?
- Started by FozzieBear
- Replies: 3
-
POTTERTON PROMAX 28 COMBI Boiler - Hot Water Issue
- Started by boiler101
- Replies: 4
-
Hole in copper pipe, solder under floor, T coupling & protection- Started by dreikher
- Replies: 0
-
-
-
-
-
-
-
-