Search the forum,

dishwasher install .

Discuss dishwasher install . in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
S

soccercelt

Messages
115
I have an opening for dishwasher which is 600mm wide however my wife wants now an integrated dishwasher. Will i still be able to install the dishwasher into this space or do i need to reduce it. We have a door in the garage that i exactly 600mm but im thinking this might not do because the door is exactly 600mm and would it not need to be 600mm plus the thickness of the panels on both sides of where the dishwasher sits now.
 
It seems the side panels would still be visable. You would need exactly a 600mm gap... At the moment the gap is between? Wall end panel?
 
Integrated alliance's fit the nominal gap, in your case 600, so the appliance is 596-598 and sits on the floor with the plinth hiding the legs. So it'll just slide into a 600 gap - or if you've got a 600 cupboard with sides reducing the gap to ~560 then just pull the thing out? I'd be surprised if door was exactly 600 as they're usually a couple of mm narrower to allow for clearance.
 
A picture of the gap would be helpful if possible. At the moment you.have a 600mm gap with an end panel either side? Or are they the sides of exsisting units?
 
Status
Not open for further replies.

Reply to dishwasher install . in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

L
My son has an Apprentice interview- please help.
My son has an apprenticeship interview for to become a plumber and heating engineer. The have said there will be a multiple choice exam for this for suitability. The thing is my son panics during tests/exams. Is there any book I can buy him to practice the multiple choice test for the exam? What...
Replies
3
Views
396
Chuck
C
A
copper vs pushfit pipes
Copper pipes, I think its fair to say, is not what it used to be, the copper is getting thin while the cost is going up. Meanwhile, plastic Pushfit seems to be getting better and better, cost and convenience was always better, but now the quality is to, have we reached a stage where plastic will...
Replies
2
Views
227
Chuck
C
sammie81116
Sewer pipe problems not sure about it
Hi all Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my toilet a good few times nothing is going to the sewer so don't know is there a blockage or what way it works many thanks and advice would be grateful
Replies
3
Views
469
Chuck
C
D
Extending outdoor tap and drain
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
213
DIwhYdidIstartThis
D
T
22mm MDPE connection
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it šŸ˜¬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Replies
1
Views
253
ShaunCorbs
ShaunCorbs
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock