Discuss Anyone recognise this? in the Plumbing Jobs | The Job-board area at PlumbersForums.net
- Status
- Messages
- 3,898
That's Ideal, that is, or variant;
You can buy the washers.
https://www.amazon.co.uk/dp/B00JBI3...t=&hvlocphy=9046381&hvtargid=pla-420234462406
You can buy the washers.
https://www.amazon.co.uk/dp/B00JBI3...t=&hvlocphy=9046381&hvtargid=pla-420234462406
Last edited:
- Messages
- 929
SV94167 part number
- Messages
- 10,444
Sure I have picked one up off the shelf at City Plumbing mate. Take the photo with you just incase
Ideal Standard/Armitage Shanks (same company). Graham merchants does a kit with a new washer and plastic plug to hold it in place.
Note that it is VERY important that there is at least a little free play beween the flush mechanism and the flush buttons on top of the cistern lid. Other than that, I think this is a good design of mechanism and worth keeping. As you say, you can also buy a new one and swap the bodies over.
Note that it is VERY important that there is at least a little free play beween the flush mechanism and the flush buttons on top of the cistern lid. Other than that, I think this is a good design of mechanism and worth keeping. As you say, you can also buy a new one and swap the bodies over.
- Messages
- 6,157
Plumbase keep a stock of armitage spares . Kop
- Status
Reply to Anyone recognise this? in the Plumbing Jobs | The Job-board area at PlumbersForums.net
Similar plumbing topics
This bath filler/overflow is supposed to turn to divert water flow to a shower above. It’s not clicking across anymore. Does anyone recognise it? Fitted in 2014. It was installed together with this Bristan inbuilt thermostatic controller.
Hello everyone,
One of the hexagonal pieces on the head of one of these bathroom basin mixer taps (Heritage Watersmith) has been lost and I am looking for a spare. Does anyone recognise the model?
Many thanks!
My father is getting quotes to have his back-boiler replaced. The firm he wants to use have told him that they will have to fit drain-offs to every radiator as this is now required by regulations. Can anyone confirm that this is correct, and which regulation has changed to now require this?
Hi, I'm trying to replace a motorhome tap and have come across these push fittings which don't seem to have any movement to enable uncoupling.
Does anyone know if these are uncoupleable and if so, how?
TIA.
Hello everyone
I need to replace this bath/shower mixer but cannot find any identification marks on it . Does anyone recognise it please. I need to replace with something similar
Many thanks
Paul
Creating content since 2001. Untold Media.
Newest Plumbing Threads
-
Trying to source a dual-flush valve
- Started by Thomas J Marshall
- Replies: 2
-
-
-
-
What constitutes a Commercial Appliance and thus a Commercial Kitchen?
- Started by FozzieBear
- Replies: 3
-
POTTERTON PROMAX 28 COMBI Boiler - Hot Water Issue
- Started by boiler101
- Replies: 4
-
Hole in copper pipe, solder under floor, T coupling & protection- Started by dreikher
- Replies: 0
-
-
-
-
-
-
-
-