My friend has a megaflow system but the flow rate at the showers in the house is awful. What is the best way to increase the pressure/flow rate for this sort of system? They already have a 25mm MDPE pipe from the mains coming in to the property. I need to quote them for fitting a shower on...
Hi all
I was wondering how i would isolate the flow to the radiators in a house which has a megaflow system.
I need to move the flow & return pipes to the opposite side of the room to install a new rad.
Any help would be great!
Thanks.
Alan.
Hi there all - we're doing a loft conversion in our house so will have a 4 bed property with 2 bathrooms - should we be going for a megaflow or a combi as a couple of gas-fitters have quoted for? They seem v keen just to rip out the old system and put in a combi - I'm not sure this would be best...
Apologies if this hass been asked before...
I am getting the bathroom completely re-done and part of this involves stripping tiles off and re-plastering. However, I want to remove the radiator that's in there and also the radiator pipes as far as the ceiling (so it can be plastered). Every...
Hi I am a new member to this forum. I am not a plumber - just an interested householder.
I have water dripping from a valve attached to a Heatrae Sadia Megaflow CL 170 unvented system.
The leaking part no is 95 605 021.
Do I need a new valve - or is this a result of a problem elsewhere in the...
Hi all, its Friday :17:
Well just been out to have a look at a faulty Megaflow and just want a few thoughts and opinions if poss (sorry if people have asked about this before)
Water is being discharged via the tundish at a v.slow rate probs about 1 drip every 5 seconds. The water being...
nysk2008
Thread
megaflow
pressure
question
system
valve
vessel
water
A strange one , I know, but this is something that I need to do. (Customer is only getting 2 bar at the mo along with 14ltrs/min flow rate)
Can anyone advise me on what would be a good pump to buy for my customer. Will be using the old c/w storage tanks as a break tank. then from there...
We are renovating our bungalow down in cornwall. We are off gas, and currently have an old oil fired boiler. After much research we've decided to stick with an oil fired boiler. What we can't decide is whether to go with a combi or a megaflow pressurised system. The place will be well...
Hi,
I have been discussing a new water system with a professional and he suggested a megaflow (due to poorish mains pressure), but also suggested a 200litre+ cold water storage feeder tank in the loft - he did try to explain that this would provide constant pressure but I thought the megaflow...
garryl
Thread
cylinder
mains
megaflow
moving
pressure
tank
water
Hi (this is my first post)
My builder has recommended a Megaflow system - in order to meet our requirement for instant hot water and high pressure power showers.
He says that the pressure and flow rate are 3.8-3.9 bar and 22l (per min I assume) - and that this should be ok for Megaflow...
cronshd
Thread
basic
builder
megaflow
pressure
questions
unvented
water
Hi All,
Has anyone got a drawing of how a typical secondary hot water return system would be set out?
I think ive got it right but just wanted to check.
Its on a 300ltr megaflow with two boilers cascading for the CH but i want to pump the DHW at peak times
Cheers
smhstu
Thread
hot
hot water
megaflow
return
secondary
system
water
Hi a plumber has recently installed a DD125 MEGAFLOW hot water cylinder into my 4th floor flat, however it was not possible to connect the safety outlet to the outside due to the original one not having this (Gledhill). At the moment i have put a bucket under it. How much of a problem is this? i...
kean
Thread
cylinder
hot
hot water
hot water cylinder
litre
megaflow
pressurised
query
unvented
water
I would be really grateful if anyone could give me advice.
My new build house has a megaflow hot water system. This overflows outside especially afer showers. This has been a problem for 2 years and the 'bubble has been reset about 8 times. When a megaflow engineer came out the message seemed to...
I am site manager of a block of flats in sunny glos. We have 35 off heatrae megaflow d 145 immersion heater tanks, half of which have leaking overflows which are damaging the fabric of a grade 2* listed building, formerly the largest woollen mill in the county. I have regenerated air pockets in...
musgrove
Thread
heatrae
megaflow
pressure
problems
relief
sadia
valve
water
Could anyone help, the megaflow system was fitted around 18 months ago, there is an old stuart turner pump ( fittrf around 10 years ago) still operating as a shower booster on the system, is this allowed as the pump is leaking a bit and needs replacing but am a bit confused as ive since been...
taffy1
Thread
fitted
illegal
mains
megaflow
plumber
pump
should
system
unvented
water
I have a megaflow system that has been working fine for a few years. Recently though (over the six months or so), Ive had to top up the expansion tank at ever increasing frequency. My plumber has changed the expansion tank (apparently the membrane had gone, so i guess it needed doing anyway)...
Mike Great
Thread
expansion
hours
megaflow
needing
pressure
system
which
HI , I wonder if there is someone out there who can help, i've got a Vaillant Ecotec 438 open vented Boiler , a VR65 control center and a Wireless VRT392F thermostat controls with a large Megaflow HE 250L tank. I have installed the VR65 as per Vaillants instructions, the Hot water and Heating...
azam
Thread
boiler
central
central heating system
connections
control
controls
cylinder
ebus
eco
hot
hot water
megaflow
open vented
pump
safe
safety
tank
temp control
temperature
vaillant
valves
water
wireless
I am looking at a megaflow that runs out of hot water quicker than it was .
I have megad both immersion heaters / stats and they read 19 ohms which is correct.
They both have a 230v supply . so i am confused as by all accounts they are ok.
Age of cylinder approx 7 years , thanks for any thoughts...
billybongo
Thread
confused
cylinder
electronic
fuse
hot
hot water
megaflow
supply
water
HI , I wonder if there is someone out there who can help, i've got a Vaillant Ecotec 438 open vented Boiler , a vr65 control center and a Wireless VRT392F thermostat controls and a Megaflow HE 250L tank. I have installed the VR65 as per instructions, S plan , the pump valve and Heating Valve are...
azam
Thread
boiler
central
central heating system
connect
connection
connections
control
controls
ebus
eco
ecotec
hot
hot water
megaflo
megaflow
open vented
pump
s plan
temperature
vaillant
valve
water
wireless
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.