Search the forum,

should

The English modal verbs are a subset of the English auxiliary verbs used mostly to express modality (properties such as possibility, obligation, etc.). They can be distinguished from other verbs by their defectiveness (they do not have participle or infinitive forms) and by their neutralization (that they do not take the ending -(e)s in the third-person singular).
The principal English modal verbs are can, could, may, might, shall, should, will, would, and must. Certain other verbs are sometimes, but not always, classed as modals; these include ought, had better, and (in certain uses) dare and need. Verbs which share only some of the characteristics of the principal modals are sometimes called "quasi-modals", "semi-modals", or "pseudo-modals".

View More On Wikipedia.org
Recent contents Top users
  1. A

    Should I Join sink waste to existing washing machine waste?

    I am installing a sink in utility room. Washing machine waste already exists and is the verical pipe with the flexib pipe from the machine poked down the top and a with a u bend at the bottow going directly to outside drain. Is it OK to put a tee joint into the verical pipe and join the sink...
  2. Dan

    3 Plumbing Tricks You Should Know? - These tips any good lads?

  3. A

    Should a plumber inform you that your new Combi boiler would be no good with a digital pump.

    Hi. I recently had a renovation done. My builder installed a new Combi boiler instead of my system boiler. He connected the pipework to the digital pump. He did not inform us that we would need a new processor because we had changed to a Combi and subsequently a valve blew. Should my builders...
  4. P

    Should I insulate vent pipes in loft (from DHW cylinder and central heating)

    Hi I recently did some pipe insulating in my loft. The only two I didn't do were the vent pipes. Not sure if that is the right term for them? They are the pipes that feed water back into the top of the tanks when there is excess, presumably from steam, expansion, etc. The one going to the cold...
  5. P

    Connector for tap with threaded tails. And should I seal the washer?

    Hi I'm going to be fitting a tap like this one: And just wanted to check that this is the correct part for connecting to 15mm copper pipe using compression: https://www.NoLinkingToThis/p/flomasta-compression-straight-tap-connector-15mm-x-1-2-/58294 If not, please could someone let me know...
  6. Gasmk1

    Ideal evomax loses its settings if power turned off

    Does the evomax lose its settings when power turned off
  7. T

    Should I Replace Hot-water Cylinder?

    I have a vented hot-water cylinder that was installed when the house was built - 38 years ago! It has a header tank in the loft and the cylinder is located directly above the ceiling of a new and expensive kitchen. It does not leak and causes no obvious problems. Should it be replaced? Advice...
  8. J

    How should a boiler be fitted to stud wall? Guidelines.

    Hi. I moved in to a new build home and 3 years later (after the builders warranty expires) the boiler is slipping off the wall at one side. This is putting pressure on the flue. Not something I’m happy with. Does anyone know the guidelines on how they should be fitted? I want to prove they...
  9. Zig168

    Should you powerflush a microbore system

    The system is about 20 years old and has never been cleaned. The radiator water looks like tar and several radiators are warm at top and cold at the bottom. What would be the best steps to clean the system? I have spoken to several engineers. One only recommends a magnacleanse due to being a...
  10. B

    What should I be ordering?! (Toilet syphon)

    Hi all - Our toilet has got very difficult to flush. A couple of very quick goes on the handle will do it sometimes, but not others! So we are considering replacing the innards ourselves. I suppose the first question is: is that sensible? ;) Assuming it is, we have looked on various online...
  11. E

    WD40 in nut on water pipe - should I be worried?

    I needed to replace the braided water pipe for the hot tap as I was putting everything back together; I placed the female end into the copper pipe and before tightening the nut below it, I thought I'd add some WD40 into the nut just to make it easier to tighten. I then realised, given it's a...
  12. M

    Where should I connect my garden tap pipe?

    Hi everyone, I'm about to install a garden tap pipe on a new build, but I'm a bit confused with the pipework I'm seeing under the kitchen sink. Here is a picture of what I'm seeing: Pipe A - Cold water pipe. Pipe B - Behind the wood plank, B connects to a valve that shuts down the entire...
  13. R

    What paperwork should a boiler installation come with?

    Hi gents and ladies, Making the probable mistake of buying a house at present : bit of a fixer with a shoddy but recent boiler installation. Have a bit of a question for our resident gas people, if you can possibly help me out here. The vendors seem to have lost the installation invoice, but...
  14. panda_96

    Bleeding air from Central Heating System

    Boiler is making a gurgling sound and keeps short cycling. I believe there is air in the the system and I've already bled all the radiators. This is the pipe leading into the water cylinder, is it where I should be bleeding the air from?
  15. S

    Should the installer repair under warranty?

    Had central heating installed 9months ago, came back this morning (after stopping at my partners lastnight) to water Soding out of my bedroom radiator, the pipe had literally dropped down and fell out of the connector going into the radiator. Should this repair be covered under the plumber who...
  16. C

    Should I increase extension plumbing to 22mm

    Ive extended my house and need to run the plumbing, I will tee off from the main house which is 15mm, I'm wondering if it's worth increasing it to 22mm with 15mm tee offs to the outlets, or should I just keep it all 15mm, I'm wanting water pressure and volume to be better if multiple outlets are...
  17. C

    Should I be worried about this installation ?

    I have just had 2 new vented hot water cylinders installed by a plumber (not yet finished) however I am a little concerned as the pipes are not attached to anything, the empty tank on the left wobbles a little on uneven floor and is slightly on the wonk. The plumber is really great but this was...
  18. M

    Should it take an hour to heat home by 2 degrees

    I have had new boiler new rads and pipes and my house takes an hour to heat up by 2 degrees is this right?
  19. G

    Should a Soffit flue extension kit be fitted ?

    Having purchased a new build, the current boiler flue terminates flush at the wall, the vented spent fumes from the boiler flue is within 300mm of the end of the vented soffit, a strip of UPVC is covering at least 400mm of the vented soffit, should an extension soffit kit be fitted to prevent...
  20. B

    Modulation - Should I Expect Efficiency

    Hi. Looking for some advice on thermostats. I've got a Vaillant 835 Ecotec Plus set up but have not yet installed a thermostat. The house is approx 100sqm, a victorian terrace but fairly well insulated under the ground floor and in the loft. It has two zones: 25sqm of liquid underfloor on a...
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock