- Thread starter Mossop
- Start date
- Replies 2
- Views 2K
- clips oil pipe pipe clips soil soil pipe solvent solvent weld weld
Discuss 110 mm soil pipe clips: solvent weld and push-fit in the Plumbing Jobs | The Job-board area at PlumbersForums.net
- Status
- Messages
- 6,157
Should be ok bud push fit and solvent weld is the same 110mm for soil pipe . cheers kop
- Messages
- 58
They will both be fine
- Status
Reply to 110 mm soil pipe clips: solvent weld and push-fit in the Plumbing Jobs | The Job-board area at PlumbersForums.net
Similar plumbing topics
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it 😬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Hello all,
I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m planning to pour a 100mm deep concrete patio on 100mm hardcore. In order to achieve the same final height to line up with the rest of the patio, I...
Copper pipes, I think its fair to say, is not what it used to be, the copper is getting thin while the cost is going up. Meanwhile, plastic Pushfit seems to be getting better and better, cost and convenience was always better, but now the quality is to, have we reached a stage where plastic will...
Hello all,
I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Hi, basic question, any insight much appreciated.
Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended floor. Pic 1 is inside porch, pex temporarily clipped to give an idea of pipe placement (ignore shoddy blockwork of booted cowboy builder!), Pic 2 is...
Creating content since 2001. Untold Media.
Newest Plumbing Threads
-
Mixer mixer shower, compatible with tanked supply
- Started by Matt0029
- Replies: 1
-
-
No Hot water, Fixed and Broken Again Ideal Logic 24
- Started by Filthbags
- Replies: 0
-
-
What's happening to this radiator, paint flaking off?
- Started by mikmikmikmik2024
- Replies: 2
-
Is it necessary to earth bond a Kitchen Sink?
- Started by Cello
- Replies: 3
-
Show us your fanciest radiators you have installed!!- Started by Lou
- Replies: 0
-
Y Plan, no hot water but heating is working when called
- Started by Chopper9495
- Replies: 8
-
-
Towel Rail Valve Advice please (35 Characters needed.)
- Started by NorthernLad
- Replies: 6
-
Unvented discharge at high level current regs
- Started by Matt0029
- Replies: 11
-
Trying to source a dual-flush valve
- Started by Thomas J Marshall
- Replies: 2
-
-
-
