How many have you lot changed?

[quality]

 

[jtsplumbing]

Do you mean the small rubber seal ?

 

[quality]

No the whole sump

 

[jtsplumbing]

No the whole sump

Not done a sump yet but had that small seal leak

 

[Harvest Fields]

Not done a dump either yet. But don’t see many Ideals at the minute.

 

[ShaunCorbs]

5 but they were on the same estate

 

[quality]

I have replace the inspection cover on 2 occasions and its been the sump thats cracked so I just replace the whole sump on them now to be certain. Pretty bad really as I have done quite a few

 

[jtsplumbing]

I have replace the inspection cover on 2 occasions and its been the sump thats cracked so I just replace the whole sump on them now to be certain. Pretty bad really as I have done quite a few

Whats involved in changing the sump ?

 

[Alpha man]

None yet, had a couple done under the Ideal warranty, done a few seal, and 1 manifold, but no doubt, it won’t be long!

 

[ShaunCorbs]

Whats involved in changing the sump ?

Not much as it just clips on, getting the old one off can be a pain if you've never done it before

 

[townfanjon]

I have never done one because all my customers have combis and from what I have heard they only go on heat-only’s

 

[quality]

I have never done one because all my customers have combis and from what I have heard they only go on heat-only’s

Ive done more on combis than heat only but then thats probably because there's more combis than heat only out there

 

[townfanjon]

Ive done more on combis than heat only but then thats probably because there's more combis than heat only out there

Blimey my lots doing well then lol

 

[Darren Jackson]

Yep I changed a few as well, I used to just change the cover but like Quality says above, I've found it to be the sump most times and wasted time just replacing the cover. So I too swap the sump out now just to be sure.

 

[Scott_D]

Not changed any, only see one cracked on a Heat only

 

[hammers4spanner]

Never done one yet.

 

[Vee]

Done one. Was quite easy. Just loosen the heat exchanger holding screw slightly to ease the back clips.