Search the forum,

Discuss Megaflow , a bit confused in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
B

billybongo

I am looking at a megaflow that runs out of hot water quicker than it was .
I have megad both immersion heaters / stats and they read 19 ohms which is correct.
They both have a 230v supply . so i am confused as by all accounts they are ok.
Age of cylinder approx 7 years , thanks for any thoughts . Mark:confused:
 
Could be lime scale arround elements if in hard water area

Eco
 
oops hit post before I finished typing,
swap the stats over - sounds like top immersion & stat is working fine and giving about 1/3 of the hot water you usually get.
Bottom stat could be iffy?
 
Thanks for replies , we are in a hard water area but it has an electronic descaler on the feed , thats not to say it could be furred up.
Will try stat swop and if push comes to shove will take them out to look at them . cheers mark
 
Status
Not open for further replies.

Reply to Megaflow , a bit confused in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Creating content since 2001. Untold Media.

OFFICIAL SPONSORS

OFFICIAL SPONSORS

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock