Search the forum,

your plumbing forum moderators

Discuss your plumbing forum moderators in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
R

REDSAW

these are the general plumbing forum moderators in this section.
any help or questions please contact via private message to any of the assigned mod's.

STEVEB
GAS MAN
BOD
SYSTEM3
PLUMBSTAR TOM
CROPPIE
REDSAW
MR DOBERMAN

​
 
Status
Not open for further replies.

Reply to your plumbing forum moderators in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Dan
  • Sticky
Australia Morning Thread
Morning to any Australians lurking around! Register its free, then message me, I'll sort your account out for you. We will need a moderator from each main country too. I'll post this in the Australian forum now.
Replies
0
Views
59
Dan
Dan
jamespipe
Plumber recommendation for heat pump HWS installation
Hi, My current hot water system needs to be replaced. Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off? An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au. How reliable is this...
Replies
5
Views
206
jamespipe
jamespipe
C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
0
Views
109
ChrisGid
C
W
Outdoor Tap at Porch
Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended floor. Pic 1 is inside porch, pex temporarily clipped to give an idea of pipe placement (ignore shoddy blockwork of booted cowboy builder!), Pic 2 is...
Replies
6
Views
199
Dave Moore
D
C
How to identify dripping tap.
Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't install any isolating cocks in the H&C feed to the tap so how can I identify which of the valves is passing? Shut the whole H&C water system down?
Replies
7
Views
185
cheddarman
C
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock