- Messages
- 997
I've just completed a full oil heating system for the most fussy, hole picking, paranoid, ignorant custard I have ever had the misfortune of working for; 2 weeks of hell glad its over and done with!
My favourite quotes of the past 2 weeks
Each morning I had ''I'am concerned'' followed some retarded **** ( listed below not in order )
I was expecting the apollo tank gauge to provide a litres reading so I could compare readings with the oil delivery slip to make sure they delivered the right amount. :veryangry2:
You have notched the joists to much.
I wasn't aware the boiler would be running when the heating was on :stuart:
I though the pipes under the floor boards would be 15mm
The water coming out the hot tap is slightly cloudy does this indicate a problem? (sunday morning @ 10am)
I read on the internet 10mm pipe only carries 4.7 kws why are you using it?
I read on the internet ''Insert ****ing ridiculous comment''
Are you going to screw the external oil boiler to the floor (NO IT ****ING WEIGHS NOT FAR OFF
QUARTER OF A TON WHEN FULL OF H20 YOU TOSSER)
You can hear the water running through the rad valves.
Are the rads closest to the boiler going to take all the heat?
You were ''X'' amount cheaper than the other guy
Your doing a cheap job because you doing 10mm drops in trunking.
The TRV's aren't 100% accurate
I knew I had got a ''wrong un'' when he said 'I'am an ''engineer'' :90:
My favourite quotes of the past 2 weeks
Each morning I had ''I'am concerned'' followed some retarded **** ( listed below not in order )
I was expecting the apollo tank gauge to provide a litres reading so I could compare readings with the oil delivery slip to make sure they delivered the right amount. :veryangry2:
You have notched the joists to much.
I wasn't aware the boiler would be running when the heating was on :stuart:
I though the pipes under the floor boards would be 15mm
The water coming out the hot tap is slightly cloudy does this indicate a problem? (sunday morning @ 10am)
I read on the internet 10mm pipe only carries 4.7 kws why are you using it?
I read on the internet ''Insert ****ing ridiculous comment''
Are you going to screw the external oil boiler to the floor (NO IT ****ING WEIGHS NOT FAR OFF
QUARTER OF A TON WHEN FULL OF H20 YOU TOSSER)
You can hear the water running through the rad valves.
Are the rads closest to the boiler going to take all the heat?
You were ''X'' amount cheaper than the other guy
Your doing a cheap job because you doing 10mm drops in trunking.
The TRV's aren't 100% accurate
I knew I had got a ''wrong un'' when he said 'I'am an ''engineer'' :90: