45 degree take off Tee

[H2Owner]

Hi folks,
I need a 45 degree take off from a horizontal pipe, I can get a 28mm x 28mm x 15mm Tee but that's a 90 degree elbow.
Does anything exist that gives a 45? I guess it would look a bit like a Y branch or Y Drain/Strainer, otherwise I'll just go for the 90 Tee with a 45 degree elbow.

Cheers

 

[Timmy D]

Just use the tee and a m/f 45. The Male end will slot straight into the tee and be pretty close to your required dimensions.

 

[Ben-gee]

Or just bend the end of the pipe you are using to 45, or any other angle you require.

 

[Chuck]

Does anything exist that gives a 45?

What you want is sometimes called a '45 degree lateral wye'. I've never come across one that is smaller than about 2". IIRC they were cast bronze and cost a small fortune. I'd avoid for domestic work and use your plan B.