Robert Tyrrell
Gas Engineer
- Messages
- 701
Good evening folks
Today i replaced a BolierMate2000 with a RM cylinders pre-plumbed UVDHW cylinder and I can't get any pressure on the gauge at the vessel.
I was wondering if I did the right thing connecting the heating return to the primary return with the flow to the pump on the cylinder and then onto the heating flow?
Of course it might just be a dodgy pressure valve but the pressure stops building after a few minutes and the gauge hasn't moved at all.
The flow through the cylinder is good with hot being at the same pressure as the CWM.
An ideas please?
Today i replaced a BolierMate2000 with a RM cylinders pre-plumbed UVDHW cylinder and I can't get any pressure on the gauge at the vessel.
I was wondering if I did the right thing connecting the heating return to the primary return with the flow to the pump on the cylinder and then onto the heating flow?
Of course it might just be a dodgy pressure valve but the pressure stops building after a few minutes and the gauge hasn't moved at all.
The flow through the cylinder is good with hot being at the same pressure as the CWM.
An ideas please?