Discuss Hepworth Plumbing fittings in the Plumbing Jobs | The Job-board area at PlumbersForums.net
- Status
- Messages
- 10,034
I don't use plastic push fit, but I have come across the green plastic gripper in Hep fittings broken into segments. No idea if that happened when the installer was pushing the fitting on, perhaps carelessly not in line, or if it just happens later.
- Status
Reply to Hepworth Plumbing fittings in the Plumbing Jobs | The Job-board area at PlumbersForums.net
Similar plumbing topics
Hi there,
I am hoping someone can give me some advice. We have had two leaks at home in the last 2 weeks; luckily we were in for both events and managed to get the water turned off pretty quickly so it is not a massive catastrophe. Both times, a fitting popped off a pipe about 15 minutes after...
I had a new Grandfos UPS3 pump fitted today, and am trying to set it up. I want it on 2nd setting, but having problems. The green light is on setting 1 and there is a yellow light on setting 2. If I press the arrow the green light stays on 1 and I then have yellow lights on settings 2 and 3. If...
Hello hello,, Hoping there are some experts or experienced Bulgarian plumbing chaps in this site ?. Here in the UK I can fit a bathroom just with the experience I have picked up over a lifetime. I can make copper pipe runs isolaters taps sink shower etc but me and the missus have bought a small...
Hi all I'm hoping someone can shine a light on this for me
Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall)
Unfortunately turning this to the closed position only reduces...
Hi, I have fitted an electric shower, teed off the toilet cold feed (Mains)
The pressure for the shower is very very poor just dribbling out.
Pressure is fine
Lpm is fine
Fitted loads like this before and never had a problem
Any suggestions ?
Creating content since 2001. Untold Media.
Newest Plumbing Threads
-
Capping a redundant gas cooker supply
- Started by Jocky B
- Replies: 0
-
-
Water pump to regulate high pressure?
- Started by Nikileaks
- Replies: 2
-
Any advice for putting this shower in ?
- Started by Staggersandfalls
- Replies: 2
-
king of pipes no reply from private message
- Started by cjg
- Replies: 1
-
-
-
Why pressure gauge drop without leak
- Started by sanju pradeep
- Replies: 6
-
Hot water so hot tap and shower via our hot water tank
- Started by thecar
- Replies: 4
-
-
Running copper pipework above / across a Gas boiler?
- Started by kristeva
- Replies: 2
-
Installing pipework to avoid airlocks
- Started by Matt0029
- Replies: 1
-
DUK Pipes for thermostat shower fitted at different heights
- Started by Delforkids
- Replies: 2
-
-