ideal logic 30 combi boiler F1 fault

[Dotty]

How much force do you get out of your hw taps? You've a blockage somewhere.

 

[buckley plumb]

View attachment 8458here is the actual photo of the loop hope this helps

i may be wrong as only fitted 2 of these a while back there was some funny set up with the early ones where when the valves are on they are not in the orientation you expext. does the mains in have to be turned to off position to divert water to the filling loop just a thought also are handles spinning on the valve spindle and you think they are turning . just thoughts

 

[bodypiercedmale]

How much force do you get out of your hw taps? You've a blockage somewhere.

plenty of force out of all the taps.thats why i am at a loss why it isnt working

 

[bodypiercedmale]

i may be wrong as only fitted 2 of these a while back there was some funny set up with the early ones where when the valves are on they are not in the orientation you expext. does the mains in have to be turned to off position to divert water to the filling loop just a thought also are handles spinning on the valve spindle and you think they are turning . just thoughts

ok i tried turning of the mains and opened the valves to top up (didnt work) also tried every combination of opening and closing all the water valves.no joy whatsoever

 

[uwantsome]

I fit these boilers everyday and there is a common fault with the filling loops. I must of had 13 filling loops stop working. If your still under warranty they will come and replace the filling loop. My are all under warranty as they are brand new and they just change them

 

[Nostrum]

Jesus, if they can't even manage to make a filling loop, it doesn't give you much confidence in the rest of the boiler.... 2 valves and a pipe, hardly rocket science!

 

[TBServices]

Jesus, if they can't even manage to make a filling loop, it doesn't give you much confidence in the rest of the boiler.... 2 valves and a pipe, hardly rocket science!

They'll be made by caleffi or someone else most likely. They are crap though. I never fit ANY boiler without an external filling loop, regardless of what's in the boiler.

 

[newagegasman]

They had loads of faulty ones so ugraded it you wont hear the rush cause the single check valve is gone.. you need a gas safe plumber to replace it with the upgraded version.

 

[newagegasman]

lol that is just the start, i do these boilers all the time.

 

[stevetheplumber]

this is sounding like the logic is no beter than the I ones

 

[newagegasman]

They had a few flaws, any information you wanna know message me i know these boilers in side out.

 

[Gerryx]

They had a few flaws, any information you wanna know message me i know these boilers in side out.

Hi, I have one of these Boilers,and am getting the flashing F1. I have a refill loop fitted, I refill up to between 1.5 and 2 on the dial. Boiler starts working, then after a few hours the Flashing F1 is back. I have good water pressure at all taps, I have also made sure there is no air in the rads. They all work when F1 is not flashing. any Ideas. You help would be greatly appreciated.

 

[Dotty]

We cannot and will not give advice on the installation or repair of boilers, cookers or ANY gas appliances for your own safety.

Please go to Gas Safe Register | Ensure your gas engineer is registered. or post a thread in the 'I'm looking for a plumber / gas engineer' section of these forums remembering to include your location. [DLMURL="http://www.ukplumbersforums.co.uk/im-looking-plumber-gas-engineer/"]I'm looking for a Plumber or Gas Engineer[/DLMURL]

If you are gsr please increase your post count to 10+ then send a PM (Private Message) with your gsr details to either Gas man - View Profile: gas man - Plumbing Forum | Plumbing Advice | Plumbers Forums | A forum for plumbers advice in the UK or Redsaw - View Profile: REDSAW - Plumbing Forum | Plumbing Advice | Plumbers Forums | A forum for plumbers advice in the UK who will check you and then give you access to the gsr private forum.

Providing gas-related advice to anybody who should not be touching gas and cannot prove their competence is unacceptable. We will take whatever action we deem appropriate to prevent such advice being given


Thank you.

UKPF TA's, Mods and Admin teams.

[DLMURL="http://www.co-gassafety.co.uk/deaths.html"]CO Gas Safety[/DLMURL]

http://www.ukplumbersforums.co.uk/central-heating-forum/42241-notice-gas-safety-related-advice.html