Discuss Ideal Logic heat 24 fan - cycles on and off all night (when in an off mode) in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Messages
4
Hi, I have an Ideal Logic Heat 24 boiler, but even when in off mode on the programmer, it constantly starts the fan up for a few seconds and then shuts down again. Any ideas please? Not good for light sleepers!
 
Best and easiest way is get a gas safe engy to have a look and maybe service the boiler

If your sure none of the programs are running
 
Appreciate that, but it's a new house, and the builders boiler engineer has serviced and confirmed the boiler is ok since we commented on this to them. I'd like to establish if this is normal though?
 
No not on a heat only boiler

Yes on a combi boiler (pre heat)
 
Thanks. it's a ideal logic heat 24 which heats an immersion tank plus the central heating so I'm fairly sure it's not a combi. It doesnt seem to be heating, just running an internal fan that's quite noisy (in the dead of night when directly above it). Any ideas why it would run?
 
Other than an anti seize function (which I'm sure the logics don't have)

Or maybe a frost stat kicking in but the boiler would fire / heat up
 
Do radiators get warm?
Is the hot water program off?
 
New build , very possible wiring fault but personally I would ring ideal up , the boiler is obviously under warrenty
 
Appreciate that, but it's a new house, and the builders boiler engineer has serviced and confirmed the boiler is ok since we commented on this to them. I'd like to establish if this is normal though?
If it is under warranty then I would just get the builders back. That is what you paid for in the first place. Peace of mind so that this did not happen. However like all new builds nowadays there is always something not quite right with them.
 
Status
Not open for further replies.

Reply to Ideal Logic heat 24 fan - cycles on and off all night (when in an off mode) in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold...
Replies
2
Views
232
My heating system comprises an Ideal Logic 12 boiler located downstairs and a Gledhill OV SOL cylinder located upstairs . The problem is that when...
Replies
1
Views
505
Ideal Logic Heat 15 System Boiler Hi. Just started to get an F3 Fan Fault on this boiler. On power up there seems to be a quiet thump from...
Replies
1
Views
967
Deleted member 120897
D
E
Have an Ideal Logic + 18 with intermittent fault. When on demand the display constantly changes from O to C but burner doesn’t start. Can fix by...
Replies
4
Views
743
Hi all, I have an Ideal Logic max 35 and have just connected my Nest thermostat via opentherm. The boiler modulates the water temp fine but as the...
Replies
37
Views
5K
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock