Multimeter recommendations?

[macka09]

Do I really need to spend £150 on a fluke for general fault finding?

 

[Murdoch]

What fault finding are you thinking of?

 

[macka09]

What fault finding are you thinking of?

Just general boiler and central heating really.

 

[Murdoch]

Just general boiler and central heating really.

so really to test what’s live?

 

[SJB060685]

All my testers read capacitance and other readings but then we work on oil burners so the added functions are ideal. As Murdoch says if you're only reading voltages, resistance and continuity etc you don't need to spend lots but it depends on what you're checking.

 

[Murdoch]

I tend to use one of these when seeing what’s going on 230v boiler set ups

DL6790 Voltage & Continuity Tester - LCD Display | Dilog (DL6790)

 

[SJB060685]

My sister bought me a Fluke T6-600 for my birthday. Haven't really used it much but run some initial tests and it seems ok.

 

[macka09]

so really to test what’s live?

Pretty much. Just resistance and stuff?

 

[IND_Nick]

Do I really need to spend £150 on a fluke for general fault finding?

I bought a Fluke 116 about 10 yrs ago and it has been brilliant. Accurate, easy to use and covers almost everything you could need to check voltage, resistance, continuity , temp etc. As with all tools you can buy quality once, if you need too. Or just pick up a cheap equivalent if you don't think you will use it much.

 

[Aquarius]

I have an Extech which is pretty good, had minor issues with the battery compartment (think it was more to do with me) paid about £35 for it. I also have an Amprobe (fluke owned company) again it’s good, but what you might need to make sure of is the resistance value range - a certain baxi Spark generator coil resistance for instance has a resistance value of about 3M ohms, some multimeters like my Amprobe only go up to 2M ohms. Amprobe cost me £20 from eBay (new).

 

[Jim09876]

Jesus Christ man what you diagnosing....screwfix £6

 

[Stu-B]

Anything waterproof and in a rubber case, oh and a big display with backlight is handy if you’re approaching 50 a little quicker than you’d like.
ive got a basic fluke, cost about £90 maybe 5 years ago.

 

[Ben-gee]

Sounds like for what you need any £10/£15 multimeter will do.

 

[Last Plumber]

Do I really need to spend £150 on a fluke for general fault finding?

Fluke 116.
It will test AC/DC Voltages, LoZ, Ohms, temp (although not accurate on mine it will serve a purpose), capacitance, mV, uA, continuity etc. A lot of the things a Heating/HVAC engineer will need it for are covered with that.
I use a few other things too but it depends on the work you do.
The 116 is not cheap but I think it is worth every penny. When it finally fails, I wouldn't hesitate to buy another the same.

 

[Gasmk1]

I have an extech multimeter, uni-t with clamp and fluke voltage leads