Has anyone been able to accurately check pre-charge pressure in 0.16 litre shock arrester. The capacity is so small that using standard tyre gauge significantly reduces pressure when reading is taken. If using pump with gauge, again pressure is lost when detaching pump from valve. Charging to 7 bar in the hope that 3-4bar will remain does not satisfy my curiosity.
Users can remove all display ads (not sponsors) for a small fee. Click for info (must be logged in)
Discuss Precharge in Shock Arrester in the Plumbing Jobs | The Job-board area at PlumbersForums.net
Reply to Precharge in Shock Arrester in the Plumbing Jobs | The Job-board area at PlumbersForums.net
Similar plumbing topics
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two...
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about...
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking?
This originally happened about 12 months ago and has happened 3-4...
Hi all I'm hoping someone can shine a light on this for me
Since our stop tap on the pavement has now been filled with sand for whatever reason...
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new...
Newest Plumbing Threads
-
See the Stunning Before and After of These 6 Local Kitchen and Bath Makeovers- Started by Dan
- Replies: 0
-
$300,000 USD Renovation for a female boss’ semi-detached house in Yio Chu Kang
- Started by Dan
- Replies: 0
-
-
-
Do you recognise this shower drain rubber seal?
- Started by JohnHa
- Replies: 1
-
Shower cold/warm - hot when flush tap
- Started by Dazgrego
- Replies: 0