Search the forum,

Registration Inspection Event, arrived today

Post new thread

Discuss Registration Inspection Event, arrived today in the Plumbing Jobs | The Job-board area at PlumbersForums.net

B

bacon_sandwich

Gas Engineer
Messages
254
Just arrived today for 6th Nov, maybe because my 5 years is coming in December, or i have been a bad boy... eeek
Anyway, i am in Spain, anybody managed to re-schedule without getting struck off.. :-(
 
I believe at most they will want a site inspection like the old days
 

Reply to Registration Inspection Event, arrived today in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

D
UK Can't get stopcock 100% closed to allow a tap repair
I have a plumber coming tomorrow to change a cartridge on a badly dripping tap on my bathroom mixer unit. There is no separate isolating valve for this tap so I'll have to close the stopcock. I tried closing it today but it won't go absolutely 100% closed and there is still a very slight flow...
Replies
1
Views
236
Chuck
C
S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
119
Lou
Lou
F
What constitutes a Commercial Appliance and thus a Commercial Kitchen?
We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is a 23.8Kw appliance with all six burners and oven on max. This was installed some 10 years ago and has passed all subsequent Gas Safety inspections as...
Replies
5
Views
451
FozzieBear
F
N
Towel Rail Valve Advice please (35 Characters needed.)
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about this one. Granddaughter just moved house and this valve decided to leak when it was closed. When open its fine. Normally I have repacked the gland on...
Replies
7
Views
186
Timmy D
T
C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
200
SimonG
SimonG
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Electrical Advice | Electricians Blog
Tiling Forums
Contractor Advice Forum
Tiling Forum UK
Tiling Forums UK
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock