Search the forum,

Discuss Shower goes cold after 5 minutes in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Messages
1
hi everyone

I’m a novice in terms of diy but wonder if you can advise me at all.

I had a new combi boiler fitted in September and everything has been fine until now.

My shower is one that comes off a mixer tap on the bath. For some reason it now goes cold about 5 minutes into a shower.

My hot water comes off the combi and the cold is direct off the mains.

If I don’t put the cold water on at all then the shower runs hot constantly with no problem. If I put the cold on even just a little bit then after the 5 minutes everything goes cold.

If I turn the cold tap off when this has happened then the hot tap continues to run but the water doesn’t come back to hot. I have to turn the hot tap off and back on again to get the hot water back.

I’m not sure why this has started happening now. My cold water has always been high pressure but it hasn’t changed that I can tell.

Any advice of simple things I can try? If I call the boiler people to come out I’m not sure if I’d be covered as the hot water is fine without the cold tap being on so it’s not the boiler that’s at fault (or is it?).

Thanks everyone
 
hi everyone

I’m a novice in terms of diy but wonder if you can advise me at all.

I had a new combi boiler fitted in September and everything has been fine until now.

My shower is one that comes off a mixer tap on the bath. For some reason it now goes cold about 5 minutes into a shower.

My hot water comes off the combi and the cold is direct off the mains.

If I don’t put the cold water on at all then the shower runs hot constantly with no problem. If I put the cold on even just a little bit then after the 5 minutes everything goes cold.

If I turn the cold tap off when this has happened then the hot tap continues to run but the water doesn’t come back to hot. I have to turn the hot tap off and back on again to get the hot water back.

I’m not sure why this has started happening now. My cold water has always been high pressure but it hasn’t changed that I can tell.

Any advice of simple things I can try? If I call the boiler people to come out I’m not sure if I’d be covered as the hot water is fine without the cold tap being on so it’s not the boiler that’s at fault (or is it?).

Thanks everyone

These sort of shower attachments are not the best thing to use a very good risk of being scalded because you cant control the temperature and an imbalance of water pressure, you would be better to install a proper thermostatic controlled one, or an electric shower
 
Status
Not open for further replies.

Reply to Shower goes cold after 5 minutes in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two...
Replies
2
Views
184
  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold...
Replies
2
Views
186
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4...
Replies
9
Views
414
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason...
Replies
3
Views
306
Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m...
Replies
6
Views
296
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock