Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Recent content by Timmy D

  1. T

    Can someone please identify what this hose is?

    It’s very unlikely someone here will be able to identify the hose itself, but they might be able to identify the tap if you provide good pictures. The hose is likely tap/manufacturer specific.
  2. T

    Shower cold/warm - hot when flush tap

    If it’s a thermostatic shower, it’s likely that it’s passing cold water into the hot supply which is reducing the temperature. You likely need a new thermostatic cartridge. If you turn off the hot supply to the bathroom with the dodgy shower and open a hot tap on the basin, do you get cold...
  3. T

    Daryl Shower Head replacement (possibly over 30 years old)

    It’s hard to say without seeing the whole Shower arm, but those flat sections are where a spanner would be attached and you would use it to unwind the swivel head.
  4. T

    What we all working on this week ?

    Just finishing up 2 x boiler installs (with custom lead roof pieces), been on hold until building exterior works/scaffolding.
  5. T

    Show us your fanciest radiators you have installed!!

    Gonna need the tools. The joint is made with a half reversed thread nipple and graphite washers. The nipple has to go in the correct way round/it to its designed half. Mine came labeled. Tbh was a lot quicker/easier than I expected. I air pressure tested them once assembled, no leaks. You...
  6. T

    Show us your fanciest radiators you have installed!!

    Forgot to take an installed photo, will when I go back to fit the other 3. The below rad comes in 2 sections due to the weight. 70kg each section. I hired their kit to join the sections. 4 x rads, £6.5k my cost to purchase….
  7. T

    What constitutes a Commercial Appliance and thus a Commercial Kitchen?

    I’m not trying to scare you to death here. But whatever any of us say on here or even any other gas companies who inspect the property, I highly recommend you getting a professional documented assessment completed by a recognised body. I would contact for advice/arrange an inspection by the...
  8. T

    Towel Rail Valve Advice please (35 Characters needed.)

    I do not believe that the end cap doesn't come off. Here are pics of mine.
  9. T

    How to reinforce shower pan threshold?

    Check the instructions, some allow wooden batten to be glue into the lip before the tray is bedded down.
  10. T

    How to identify dripping tap.

    Good job, in future, use full bore lever valves with a packing nut. Whenever I have to use these screwdriver valves, theres a 50/50 chance it will leak and need replacing.
  11. T

    How to identify dripping tap.

    Can you turn off the supply to just the cylinder, then open hot tap to drain hot system. If it continues to drip, its the cold. Either way, i always replace cartridges in pairs.
  12. T

    Brass tap body is leaking.

    Should have oring on cartridge creating a seal. Make sure tap threads are clean, lubricate cartridge oring and tighten.
  13. T

    How to identify dripping tap.

    Turn stopcock off. That should stop cold. If you’ve a combi boiler, turn it off, the cold stopcock will also stop the hot. Open kitchen tap hot and cold, then open upstairs bathroom hot and cold. Water will stop after a min. If you’ve got a hot water tank. If an unvented/mains pressure, same...
  14. T

    I wish to add a second boiler to my existing meter. Location 20m away.

    Depends on size of meter
  15. T

    Recent boiler room upgrade

    Very satisfying. About 3 weeks. Currently doing another boiler room with 2 x 120kw boilers, will post when completed.
See more

We recommend City Plumbing Supplies, BES, and Plumbing Superstore for all plumbing supplies.

Featured Content

Sponsors

Electric Underfloor Heating The Wetroom Store Heating 2 Go Electrical Goods - Electrical Tools - Brand Names Official UK Plumbers Forums Facebook Page PowDer Flush Gas Talk Group | Gas Safe Register
Back
Top