Hi,
I'm struggling for months to get help on identifying a shower mixer. Bristan just say they are busy for months. Can anyone help me identify the type of mixer? We think it is an 06734b. We are not sure. If we try and chance it our plumber says we will be without hot and cold water and would...
Im coming up with mixed information on how to correctly fit my shower tray.
Its a steel framed, acrylic capped shower tray from crosswater like this
The underside of the tray is flat, and has several circles marked out in black marker, which i believe are the load points locations for riser...
Hi all,
Having a new bathroom fitted this week and looking for advice on how far we should go with waterproofing it.
The bathroom will be tiled floor to ceiling and will have a penta/corner shower cubicle, a sunken bath. Pan to wall toilet and a vanity unit / basin.
top down Layout and...
Help..... So we have an internal filled SiamP toilet push panel flush toilet system. My Son has just used the toilet and flushed it fine and then went and washed his hands. When I went to flush it after him it flushes fine but wont fill!! If you however turn on the sink or bathroom cold water...
I am having issues with my Concealed Shower Valve, Its blending too hot, ive put this down to the shower cartidge probably needs a clean as its only been working ok for a year.
Shower is fed on a 1.5bar pump with header tank.
my main issue though is ive moved all the knobs and faceplate but to...
Hi - I hope you can help. We have a discontinued Daryl Shower - the Daryl Hydra 400 that is integrated into the Daryl shower cubicle (at least I think that's what it is from looking online). The foot washer part of the shower is dripping and we have been told that the flow cartridge needs...
hi all
i was fixing a leak in my loft shower room. the photos show after i had removed the plaster off the walls. on the edging photo i've measured 20mm from brick to shower tray. on the shower facing side i've measured 13mm. tile is 7mm thickness. i was wondering, rather than pack it out...
Hey there,
I purchased a black slate shower tray from a supplier. The supplier recommended that we cut it down to our required size. Is this good practice/possible? Some plumbers I speak to say absolutely not to. Others seem OK with the idea.
I hope to cut it down to around 1600x700. Cutting...
Never fitted a corner sink and am unsure how the brackets should be used?
I'm putting in wood fixing behind plasterboard today so thought I would dry run fitting the sink.
Fitting the brackets as in the top pic leaves a gap all round the sink making it unstable.
The bottom method makes the sink...
Hello,
I’m doing a DIY bathroom job and would be very grateful for some advice.
The bathroom is in a 2nd floor flat in a converted Victorian house. The bathroom walls for the corner into which the bathtub and shower will sit appear to be dry walls with wool insulation, foil backed...
Hi
Our pop up bath plug is sticking, looking for suggestions to fix it please. Wondering if WD40 might stop it sticking or will I need to replace a part?
Many thanks.
Hi,
We have a hinged shower screen attached to a bath. It swings backwards and forwards. However, we want to stop this movement so the screen stays in a fixed position.
Can someone help achieve this please.
Good afternoon guys,
I was wondreing if anyone could help with the issue I have at home.
I have a MIRA offset quadrant shower (built around 3/4 years ago approx), and I am having leakings (see attached the photos). I have tried to put some silicone several times but the water is still going...
Hello...removed old shower tray and want to install a new shiny tray...see pictures
How should I proceed ? Tray is ceramic about 50 kg
Thanks in advance..
Hi guys. Would appreciate some thoughts on installing a waterproof good quality laminate floor in a large bathroom with tiled walls. This appears to be frowned upon in the past with the few old discussions I've pulled up but these days with today's materials and ideas is it doable? There's a...
Hi,
I am having to lift the shower tray off the floor and the ceiling height is approximately 2.3 m as per the standard for modern houses. With a fairly standard 2 m height door, this only leaves 170 mm gap between the top of the door and the ceiling and I wonder if this is sufficient for...
Hi, I am fitting at Stuart turner shower mate eco 1.5 bar.
My question is, can the inlet be from a 15mm source? The provided flexible hose that comes with it is 15mm.
I just cant get get to the 22mm pipe easily.
What are your thoughts?
Cheers
Hi, The mixing tap swivel in my bathroom sink has began to leak. Can anyone tell me if it's repairable or if it needs replaced. I attached a few photos. Is it possible to remove it from the top and add a new seal.
I have a friend that has fitted a toilet from Island bathrooms. The customer bought the toilet their self. There seems to be a problem with filling. I went and looked myself yesterday evening. first flush fills as quick as you would expect when the water is turn back on. Flush again and very...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.