Search the forum,

Is it possible to connect a bath to a macerator?

Post new thread

Discuss Is it possible to connect a bath to a macerator? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
J

Jo the boat

Messages
8
Planning to install a Sanniaccess 3 or Grundfos Sololift2 WC-3
Primarily for toilet, basin and shower use but the shower will be over a bath with occasional bath use only.
Read all sorts of information (including RPM's 10 golden rules) but unsure whether I can connect to a bath (with correct pipe fall)?
(Lift will be 3.5m in 22 mm then 7m fall to soil connection in 32 mm)

Thanks
Jo
 
Shouldn't really connect a bath to either of those pumps.
Whilst neither have the approval rating both will do the job however you can throw the warranty away.
 
Oh, that was from Saniflow technical dept. Difficult to know who to take advise from. Thanks for the reply anyway. Is there another alternative?
 
Jo the boat said:
Oh, that was from Saniflow technical dept. Difficult to know who to take advise from. Thanks for the reply anyway. Is there another alternative?
Click to expand...

Did you mention the bath, if so then you were misinformed by a muppet of which there are plenty in that office.
Product details for SANIPLUS
It`s the same for the access range I`m afraid. Other than 2 pumps just do it with a Saniplus Jo and as I said throw the warranty away after 2 days use because if it works for 2 days it will work for 2yrs PROVIDING you understand the pumps limits of what it will cope with.

(Nods to quality for his kind words.)
 
Hi Jo the boat,,,, i know youve said its for wc, basin and shower which it will do no problem but the issue is the bath, the only one that will do the bath is the saniaccess pump but obviously wont do wc,
 
kris said:
Hi Jo the boat,,,, i know youve said its for wc, basin and shower which it will do no problem but the issue is the bath, the only one that will do the bath is the saniaccess pump but obviously wont do wc,
Click to expand...

Err, You forgetting the Sanivite or the Sanispeed, the Sanicom range or the Cubic range then kris.
 
Status
Not open for further replies.

Reply to Is it possible to connect a bath to a macerator? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

U
Below Ground Soil Pipes on Self Build Bungalow
Just started gound work on self build bungalow and wondering best way to do below ground soil pipes. For toilet I was going to go straight down through slab and out through deadwork into a manhole. I will work out falls from manhole and set the height of the waste water system as required. For...
Replies
2
Views
81
umiq88
U
S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
91
Lou
Lou
P
Repeated Airlock in Bathroom
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
312
Chuck
C
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
181
dreikher
dreikher
F
  • Question
No Hot water, Fixed and Broken Again Ideal Logic 24
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
2
Views
105
Lou
Lou
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock