Search the forum,

Do you like my new van

Post new thread

Discuss Do you like my new van in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
townfanjon

townfanjon

Esteemed
Plumber
Gas Engineer
Subscribed
Messages
8,642
IMG_0377.JPG
Do you think I should get it signwritten
 
Yes you need to sign it up mr dastardly
 
You want have problems with humps though.. how many Liters :)?
 
Matchless.plumb said:
You want have problems with humps though.. how many Liters :)?
Click to expand...

It has a hybrid engine with autobox, does 0 - 60 in a couple of hours , I have a tracker fitted incase some little scrote trys to nick it , and its the dogs gonads when it comes to pulling the burds .
 
Is it me or does your offside rear tyre look a little threadbare....lol regards Turnpin:)
 
Looking good your planning on touring the county
 
It looks like a Dodge van in the US. Most likely the Huddersfield team coach for their USA pre season tour. :D
 
This is what happens when you take your van to get ply lined by a man you met in a pub. Lol
 
Status
Not open for further replies.

Reply to Do you like my new van in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Lou
Show us your fanciest radiators you have installed!!
Show us your fanciest radiators you've installed! We would love to see them! I love this Milano vertical radiator in the kitchen space. What do you think?
Replies
4
Views
163
Timmy D
T
D
Extending outdoor tap and drain
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
226
DIwhYdidIstartThis
D
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
186
dreikher
dreikher
B
Unvented hotwater cylinder
Fitted unvented hotwater cylinder building control looking forms signed it off job was in england i am qualified northern ireland send out a form to fill in what do u need to sign off in england as building control said they dont give out forms like they do in northern ireland
Replies
4
Views
196
ShaunCorbs
ShaunCorbs
N
Towel Rail Valve Advice please (35 Characters needed.)
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about this one. Granddaughter just moved house and this valve decided to leak when it was closed. When open its fine. Normally I have repacked the gland on...
Replies
7
Views
184
Timmy D
T
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock