Search the forum,

Birmingham

Post new thread

Discuss Birmingham in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
quality

quality

Plumbers Arms member
Plumber
Gas Engineer
Messages
4,294
Anyone around B40 area who fancies a pint or two I'm here all week
 
Status
Not open for further replies.

Reply to Birmingham in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
175
Lou
Lou
jamespipe
Plumber recommendation for heat pump HWS installation
Hi, My current hot water system needs to be replaced. Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off? An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au. How reliable is this...
Replies
6
Views
334
oz-plumber
O
J
Leak detection company
Does anyone know a good, not super expensive, leak detection company in the London area?
Replies
0
Views
312
John-sjw
J
M
Central heating losing pressure all the time
Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up to 1.3. I've had an engineer look inside the boiler and he can't see anything wrong. I've checked the pipes all over the house and cannot see any...
Replies
2
Views
246
PSxxxxxx
P
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
219
dreikher
dreikher
Creating content since 2001. Untold Media.

Newest Plumbing Threads

DIY Talk
Electrical Advice
Tilezine Tiling News Tile Association
Electrical Blog
BS 5389 Tiling Standards
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock