compression fittings

Post new thread

Discuss compression fittings in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
No there not. Its not know different from having the fitting under the floor. ie: you would have to remove the gas fire to gain access/ have to remove the floor boards to gain access. Only applies to gas pipes.
 
Status
Not open for further replies.

Reply to compression fittings in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

B
What is correct toilet supply line
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic...
Replies
2
Views
234
ShaunCorbs
ShaunCorbs
A
copper vs pushfit pipes
Copper pipes, I think its fair to say, is not what it used to be, the copper is getting thin while the cost is going up. Meanwhile, plastic...
Replies
2
Views
311
Chuck
C
W
Outdoor Tap at Porch
Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended...
Replies
6
Views
303
Dave Moore
D
C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new...
Replies
1
Views
271
SimonG
SimonG
N
Towel Rail Valve Advice please (35 Characters needed.)
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about...
Replies
7
Views
257
Timmy D
T

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock