- Messages
- 7,712
anyone recommend decent set of cutters for trac pipe that dont cost the earth?
ones i have got dont have deep enough blade to cut into them
ones i have got dont have deep enough blade to cut into them
- Thread starter hammers4spanner
- Start date
- Replies 2
- Views 1K
- blade cutter cutters
Discuss cutters in the Plumbing Jobs | The Job-board area at PlumbersForums.net
- Status
- Messages
- 2,168
K
kirkgas
Monument pipe cutter, with a new blade
- Status
Reply to cutters in the Plumbing Jobs | The Job-board area at PlumbersForums.net
Similar plumbing topics
Can anyone recommend a decent multi meter, preferably under a 100 pounds. It's for checking boiler components so I don't need a top spec one...
- Question
Boiler is SIRIUS THREE FS 70 Potterton commercial.
Situation: We are small building contractors and my labourers managed to damage the radiator...
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16...
Pipes for thermostat shower have been fitted at different heights. Any way of rectifying without ripping all tiles. So for clarity 15mm pipes...
- Delforkids
- Bathrooms, Showers and Wetrooms
Hello all,
I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m...
Newest Plumbing Threads
-
How much would you pay for a universal flush valve that enables replacements in under 5 minutes?
- Started by Professor
- Replies: 8
-
Bossing shower waste into soil pipe vs. separate shower waste- Started by CitizenErased
- Replies: 3
-
UK Advice on waste water pump in first floor flat
- Started by kbqwert
- Replies: 3
-
AM18x1 femail to 1/2" hose connector.
- Started by Adaminspace
- Replies: 0
-
Off grid shower and toilet solution needed
- Started by TpXThinnr
- Replies: 5
-
Expansion vessel size unvented hot water
- Started by Matt0029
- Replies: 2
-
Acrylic bath manufacturing standards/dimensions
- Started by Michelle
- Replies: 2