Search the forum,

Exposed thermastic shower valve 2mm inlet

Post new thread

Discuss Exposed thermastic shower valve 2mm inlet in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
M

Mark Ranford

Messages
1
I need to replace an exposed thermastatic shower valve with 22mm inlets and centres of 140mm. Any idea where they can be purchased?>
 
Is this a bar shower ? with 22mm nut at the back ? if so that is a standard size so most bar showers will fit, photo would help.
 
Status
Not open for further replies.

Reply to Exposed thermastic shower valve 2mm inlet in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

F
Mystery Mira Elite QT Leak
Hi All I have a leak coming from within my Mira Elite QT shower. It seems to be flowing from behind the switching Control. Any ideas what could be causing this leak. Already Changed the Pump Elbow as one of the clips had popped which was causing a second small leak, Any idea? Is it time to buy...
Replies
0
Views
228
Firefox
F
C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
189
SimonG
SimonG
B
What is correct toilet supply line
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic nut about the same size as the one going into the cistern but has a different thread. Attached is a photo. Can you advise. Thanks.
Replies
2
Views
182
ShaunCorbs
ShaunCorbs
C
How to identify dripping tap.
Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't install any isolating cocks in the H&C feed to the tap so how can I identify which of the valves is passing? Shut the whole H&C water system down?
Replies
12
Views
316
Timmy D
T
jamespipe
Plumber recommendation for heat pump HWS installation
Hi, My current hot water system needs to be replaced. Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off? An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au. How reliable is this...
Replies
6
Views
281
oz-plumber
O
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock