Discuss Hints, tips & secrets of plumbing - No Banter please! in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
if you come across a deck sink tap thats leaking from the spout to deck joint and theres no grub screws. turn the spout usually to the right so its parallel with the cold head and pull and wiggle it up. theres a spring loaded bearing and a slot in the deck that makes it only possible to pull out at this angle. re o ring and replace..jobs a goodun.
 
Last edited by a moderator:
I will remember that one changed my mothers only yesterday for the reason that I couldn't find a grub screw! to be fair it was time for a change anyway
 
Get a ladder base mate
a8yhy3u2.jpg


Then ur ladder will be a lot safer when ur on the 3rd floor roof. Or helping dickie of his horse. Also a ratchet strap fastened to wall will make u a lot safer !
 
Get a ladder base mate
a8yhy3u2.jpg


Then ur ladder will be a lot safer when ur on the 3rd floor roof. Or helping dickie of his horse. Also a ratchet strap fastened to wall will make u a lot safer !

Who's been on a ladder access course then :smile:
Don't forget your ropes and bucket hook :lol:
 
Need to change a syphon that wont flush.get a hose that is long enough to reach the pan and suck. Oviously not while in the pan. If its low enough the hose will syphon out the water and you can whip it off the wall without being full. :)
 
Need to change a syphon that wont flush.get a hose that is long enough to reach the pan and suck. Oviously not while in the pan. If its low enough the hose will syphon out the water and you can whip it off the wall without being full. :)

Bloo loo tastes worse than diesel. I'll stick to a sponge :wink:
 
Wet vac indeed. But if you dnt have one. Oh yeh tamz, like limescale on cylinder when drainoff dnt work lol.
 

Aye right Simon. I'll humpf a hoover up a flat stair to suck 2 pint of water out a cistern. Don't think so. I'd have the job done before you got it out the van even if it meant cracking the ballvalve jamb nut and wiping it up with a towel :wink:
 
Keep some spare test nipples in your bag! Nothing worse than one snapping off or worse loosing it in a semi concealed ! If u do snap off head of nipple simply get a good flathead screwdriver, put inside test point and give it a few whacks with hammer to get grip and unscrew! Obviously only should be done by a GSRI
 
Status
Not open for further replies.

Reply to Hints, tips & secrets of plumbing - No Banter please! in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Newest Plumbing Threads

Back
Top