Search the forum,

Discuss Hive Smart Thermostat & Heatmiser UH4 wiring center in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
U

Unregistered

Hi chaps,

I was looking at getting Hive Multizone for our central heating and underfloor heating. The underfloor heating will be mostly heatmiser controlled with everything wired into a Heatmiser UH4 wiring center.

I wanted to know if Hive was compatible with this wiring center?
 
Please register with us and start a new thread to receive an answer to your question.
 
Status
Not open for further replies.

Reply to Hive Smart Thermostat & Heatmiser UH4 wiring center in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi, I have a Worcester 28i junior boiler that has started to lose pressure, only when using the central heating. When using hot water I have no...
Replies
6
Views
231
  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold...
Replies
2
Views
187
Hi All, I am looking to take my bath out and fit a shower. Regards to tanking. Is it ok to just seal everything with plastic rather than just...
Replies
3
Views
253
Hi everyone, Looking for a bit of advice, recently went to a job where heating was operating when called for however not for the hot water. I...
Replies
8
Views
358
We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is...
Replies
5
Views
532
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock