Search the forum,

Identify these taps Please.

Post new thread

Discuss Identify these taps Please. in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
P

PaulGarrod

Messages
3
Can anyone identify these taps? They are leaking and I can find no way to get at the cartridge. There are no grub screws. The pix show the whole kit plus 2 closeups 1 with the rear collar slipped off. Thanks in advance.
upload_2018-2-18_19-36-35.jpeg
upload_2018-2-18_19-36-55.jpeg

upload_2018-2-18_19-37-14.jpeg
 
Forgive me if im.wrong but does the centre part covering the spindle wind out for you to be able to get a spanner on the threads?
 
Hi, Thanks for the response. My assumption was that the part nearest the wall should be restrained with a boa wrench or similar and the other, equal sized part in front of it wound out. Otherwise the grouting would be damaged. But. I didn't want to try this out without trying to find out if this was correct. In the end I might just have to have a go. trouble is if I do break something I don't know where to look for a replacement.
 
Status
Not open for further replies.

Reply to Identify these taps Please. in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
157
Lou
Lou
C
How to identify dripping tap.
Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't install any isolating cocks in the H&C feed to the tap so how can I identify which of the valves is passing? Shut the whole H&C water system down?
Replies
12
Views
374
Timmy D
T
B
Brass tap body is leaking.
I have attached an image of the brass body within a tap. Having replaced a cartridge which has cured a leaking tap, I can see that there is a small leak from the brass body which can be unscrewed. Is there a seal behind the body? Thanks.
Replies
2
Views
323
Bp89
B
R
squeaky grohe bathroom tap 2 months old
Hi bit of a weird issue, I installed a grohe bathroom tap successfully 2 months ago bought from screwfix. Last week the right hand hot tap makes a squeak noise as I turn it on or off, left tap is 100% perfect and noiseless. This grohe tap is like one unit, so no screw notch or way I can remove...
Replies
7
Views
283
Raff
R
D
Extending outdoor tap and drain
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
244
DIwhYdidIstartThis
D
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tiling Advice
UK Tiling News
Plumbing Advice
UK Tiling Forum
Tiling Advice Live
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock