Search the forum,

Looking for help to connect new thermostat to existing controller

Post new thread

Discuss Looking for help to connect new thermostat to existing controller in the DIY Plumbing Forum area at PlumbersForums.net

K

Kingerna1

Messages
7
I had a indirect hot water tank replace under warranty and it has a different style thermostat that requires more wires than my old one that only had 2. Im in the middle of nowhere and help is hard to find so I thought I would post here. If somebody can direct me in the right direction to what point on the thermostat to what point on the controller would help me extremely.
7v9i43f2vn6p.png

a2wzfg0hvwyv.png
 
I think you'll need to provide a bit more information about the equipment you have. Make / model numbers and maybe a photo or two.

Broadly speaking cylinders and controls come with 'Installation Instructions' that contain the information needed.

Are you the owner or an installer? If the former, it seems strange to me that a warranty replacement was not installed and benchmarked, i.e. left in proper working order.
 

Reply to Looking for help to connect new thermostat to existing controller in the DIY Plumbing Forum area at PlumbersForums.net

Similar plumbing topics

T
22mm MDPE connection
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it 😬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Replies
1
Views
296
ShaunCorbs
ShaunCorbs
D
Extending outdoor tap and drain
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
263
DIwhYdidIstartThis
D
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
220
dreikher
dreikher
S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
177
Lou
Lou
M
Viessmann external flue run conundrum
Hi all. Hope you have all been keeping well. A while back I decided I only wanted to fit one brand of boiler and decided on Viessmann due to space for servicing and changing parts if ever needing to. I am finding my decision rather hard due to the different clearances on flue runs and cupboards...
Replies
9
Views
259
mutley racers
M
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Contractor Advice Forum
Tiling Tools for Beginners
Tilers' Talk
Tiling Tools
Tile Cutters
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock