Discuss Low pressure and tepid hot water to shower. in the USA area at PlumbersForums.net

Messages
1
I have two identical gravity fed Triton thermostatic showers both fed from a Heatrae Sadio tank. Which is fed from the gas central heating boiler.
The problem I have is that one of the showers has developed low pressure and the hot water coming from it is only just hot enough.

The other shower works perfectly with a good pressure and plenty of hot water.

All the hot water taps in the house have good pressure and plenty of sufficiently hot water.

Any Ideas ?
 

Reply to Low pressure and tepid hot water to shower. in the USA area at PlumbersForums.net

Similar plumbing topics

  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold...
Replies
2
Views
221
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two...
Replies
2
Views
220
Hi everyone, Looking for a bit of advice, recently went to a job where heating was operating when called for however not for the hot water. I...
Replies
8
Views
397
Hello, I am seeking some advice, I have a POTTERTON PROMAX 28 COMBI Boiler and I noticed yesterday that the water around the house is no longer...
Replies
4
Views
290
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new...
Replies
1
Views
272
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock