Discuss mlcp rat question (with some extra characters in the thread title) in the USA area at PlumbersForums.net
- Messages
- 34,340
- Solutions
- 2
I find they like to eat the fittings more than the pipe haven’t had one that’s tried yet so go with metal fittings
Reply to mlcp rat question (with some extra characters in the thread title) in the USA area at PlumbersForums.net
Similar plumbing topics
Hi, basic question, any insight much appreciated.
Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended floor. Pic 1 is inside porch, pex temporarily clipped to give an idea of pipe placement (ignore shoddy blockwork of booted cowboy builder!), Pic 2 is...
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic nut about the same size as the one going into the cistern but has a different thread. Attached is a photo. Can you advise. Thanks.
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it 😬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Hello all,
I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Creating content since 2001. Untold Media.
Newest Plumbing Threads
-
Running copper pipework above / across a Gas boiler?
- Started by kristeva
- Replies: 0
-
Installing pipework to avoid airlocks
- Started by Matt0029
- Replies: 1
-
-
-
SPorcelanosa KRION Attica screen 1.2m, anyone?
- Started by Sebastian T
- Replies: 0
-
Cistern filling one third of the way
- Started by dwaindigital
- Replies: 3
-
Boiler losing pressure only on central heating- Started by SnosRap75
- Replies: 6
-
tanking. Is it ok to just seal everything with plastic.
- Started by Staggersandfalls
- Replies: 3
-
Pop quiz, does anyone recognise this radiator valve?
- Started by dimuc
- Replies: 3
-
SUsing coil to clear pipe leading to gutter
- Started by Sonya K
- Replies: 1
-
Replacing outdoor P-Trap Gully with Bottle Gully
- Started by DIwhYdidIstartThis
- Replies: 0
-
-
-
-