Search the forum,

Discuss New Worcester 34cdi classic. Hot water ok, Flow hot, return cold, all rads cold in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
N

Neilly

Have new boiler installed. Central heating and hot water all working before replacement. Flush etc all carried out before replacement. Hot water heats perfectly but no radiators heat and no heat in flow to any radiator. Tried crossing flow and return but no joy. Doesn't seem to be a block in the pipes as checked section where heat is lost. Suspect boiler issue - any thoughts?
 
Who fitted the boiler ?
 
New install?
Why not get the installer back. If it's a boiler problem, it will be under warranty. If it's been registered by a gas safe engineer?
 
New install?
Why not get the installer back. If it's a boiler problem, it will be under warranty. If it's been registered by a gas safe engineer?
 
and this is not me before any of you are asking lol , mine is running great received gas safe cert the other day

Glad everything was ok for you and your happy
 
Doesnt matter who fitted it, its Worcester that'll come out to check it under the warranty.

Edited. No gas appliance repair advice given on the open forum.
 
Last edited by a moderator:
Status
Not open for further replies.

Reply to New Worcester 34cdi classic. Hot water ok, Flow hot, return cold, all rads cold in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
2
Views
149
Hi everyone, Looking for a bit of advice, recently went to a job where heating was operating when called for however not for the hot water. I have changed the 3 port actuator Honeywell head however this doesn’t seem to have solved the issue, does this mean that the programmer is faulty? Or is...
Replies
8
Views
311
Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up to 1.3. I've had an engineer look inside the boiler and he can't see anything wrong. I've checked the pipes all over the house and cannot see any...
Replies
2
Views
229
P
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
153
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
362
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock