L
lowrider1
ive just had my boiler so called repaired, the fan was replaced and the air pressure switch ravenheat 85csi but when the hot water is turned on the flame just goes high and low
- Thread starter lowrider1
- Start date
- Replies 3
- Views 1K
- cutting cutting out flame high ravenheat
Discuss ravenheat high flame cutting out in the Plumbing Jobs | The Job-board area at PlumbersForums.net
- Status
- Messages
- 34,366
- Solutions
- 2
Call him back if he hasn't fixed it
D
Dotty
And again today.
Amy. We have specific rules on this forum. One of those is that we do not give advise on the installation or repair of gas appliances. At all. In any shape or form.
Please call in a competent gsr.
Amy. We have specific rules on this forum. One of those is that we do not give advise on the installation or repair of gas appliances. At all. In any shape or form.
Please call in a competent gsr.
- Status
Reply to ravenheat high flame cutting out in the Plumbing Jobs | The Job-board area at PlumbersForums.net
Similar plumbing topics
IS IT POSSIBLE TO ADJUST THIS MIXER UNIT? WE HAVE TO HAVE IT TURNED ALMOST FULLY ANTI CLOCKWISE TO GET HOT WATEROUT.
THE FRONT PLATE WITH MIRA ON...
Hi, basic question, any insight much appreciated.
Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended...
- Sticky
Morning to any Australians lurking around! Register its free, then message me, I'll sort your account out for you. We will need a moderator from...