Search the forum,

what tool to open this?

Post new thread

Discuss what tool to open this? in the Plumbing Tools area at PlumbersForums.net

Hashtag246

Hashtag246

Messages
3
Hi, got a porcalenosa mixer shower that i need to replace the valve on it. Not sure what tool is used on it as it looks unusual. please see photos with details
many thanks
1.jpg
2.jpg
3.jpg
 
Not the approved way but....either grab the outer edge real hard with some grips to ensure you don’t slip and mess up the thread. If that’s not possible, stick a flat screw driver in to one of the grooves as vertical as possible and hit it with a hammer to get it moving.
 

Reply to what tool to open this? in the Plumbing Tools area at PlumbersForums.net

Similar plumbing topics

S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
153
Lou
Lou
B
What is correct toilet supply line
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic nut about the same size as the one going into the cistern but has a different thread. Attached is a photo. Can you advise. Thanks.
Replies
2
Views
198
ShaunCorbs
ShaunCorbs
N
Towel Rail Valve Advice please (35 Characters needed.)
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about this one. Granddaughter just moved house and this valve decided to leak when it was closed. When open its fine. Normally I have repacked the gland on...
Replies
7
Views
207
Timmy D
T
M
Central heating losing pressure all the time
Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up to 1.3. I've had an engineer look inside the boiler and he can't see anything wrong. I've checked the pipes all over the house and cannot see any...
Replies
2
Views
226
PSxxxxxx
P
jamespipe
Plumber recommendation for heat pump HWS installation
Hi, My current hot water system needs to be replaced. Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off? An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au. How reliable is this...
Replies
6
Views
311
oz-plumber
O
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tile Cutters
Electrician Talk Forum
Plumbing Advice
Tilers Forums UK
Tile Blog
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock