Search the forum,

Discuss Which shower can I have with an old Baxi bbu in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Messages
1
Hi,
I am a newbie......just bought an older house looking to fix it up. Just didn't realise how bad things would be.
Can I please ask I have an old baxi bbu......and the shower I have fitted it just terrible.....it just sorts of splutters, there is no real water pressure and it is hit and miss if it actually works at all. I have had a couple of people out and they all say it needs ripping out and a combi putting in. And of course I realise that. But because everyone is so busy and can't fit me in and money is tight because I need a full electric rewrite in the house. So can't I replace the shower with a power shower or electric one. I just think the plumbers see the bbu and are just not interested in helping me.
 
other than using a pump your stuck, if your going down the re wire route get an electric one fitted
 
Your shower is nowt to do with the Boiler.

Apart from the temp of hot water.

You need a good experienced (probably older), heating engineer / Plumber to give sound advice.

In my opinion, Iā€™d ignore the ā€œrip it out and fit a combiā€ brigade. Itā€™s the easiest option for them but not necessarily right for you.
 
Is your shower directly below the tanks in loft. Head being like 0.5m? Thats your problem... Either raise the tank in attic as high as possible. Put a bigger tank in for better pressure. (Alot of work) or fit a booster pump...which can be noisey.
 
Status
Not open for further replies.

Reply to Which shower can I have with an old Baxi bbu in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
115
Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up to 1.3. I've had an engineer look inside the boiler and he can't see anything wrong. I've checked the pipes all over the house and cannot see any...
Replies
1
Views
132
Hi all. Hope you have all been keeping well. A while back I decided I only wanted to fit one brand of boiler and decided on Viessmann due to space for servicing and changing parts if ever needing to. I am finding my decision rather hard due to the different clearances on flue runs and cupboards...
Replies
9
Views
194
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it šŸ˜¬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Replies
1
Views
263
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about this one. Granddaughter just moved house and this valve decided to leak when it was closed. When open its fine. Normally I have repacked the gland on...
Replies
7
Views
184
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock