Today's install.

[Mike Jackson]

Nice job ,, Can't see the balance valve on the cylinder return , !!!

Under Part L balance valves shouldn't be fitted to the hot water primaries. The balancing valve is to ensure that there is capacity to run the heating and hot water at the same time. Modern control systems allow the water heating to be timed earlier than the heating which enables a quicker more efficient heat up time with no detrimental effect on the heating.

i reckon it's an Apollo Fanfare being fitted.

 

[Whn1]

yep should have one on coil flow pal, all covered in MI's

"it is reccommended that an air bleed point or automatic air vent is incorporated in the primary return pipework close to the megaflow eco unit"

surley my vent near the boiler should suffice? What would everyone else do?

 

[SafeGasInstall]

Vent on flow and return next to unvented cylinder and vent on flow to vented cylinder !
Vent I use is manual not automatic on sealed systems !
vent on open vent I use are automatic

 

[Balmoral]

as we say up north that is golden

 

[hammers4spanner]

"it is reccommended that an air bleed point or automatic air vent is incorporated in the primary return pipework close to the megaflow eco unit"

surley my vent near the boiler should suffice? What would everyone else do?

what i would do is loose no sleep what so ever over an air vent

 

[vern]

what i would do is loose no sleep what so ever over an air vent

lol i would be more worried over getting bumped!

 

[Whn1]

And the winner of 4 kazillion points is...... Gasmanrob.


Clapclapclapclapclap.

 

[Whn1]

And before you Lot start going on this was before the condensate was finished.

 

[vern]

And before you Lot start going on this was before the condensate was finished.

never mind that, whers all the beer gone?

 

[Whn1]

Pahah that's why the apprentice nearly cut his finger off today!

 

[dave1]

Lovely job mate.

 

[hammers4spanner]

flue's not sealed

 

[Destroyer2813]

Where's the frost and pipe stat ?🙂

 

[SafeGasInstall]

You will regret the day you post a picture here !

 

[Whyme]

Did you use a level on the dhw drawoff or is it my computer screen....Ive learned a valuble lesson over the last few days, Never ever post pictures too you lot haha. well done whn1. brave lad :wink5:

 

[Whn1]

Where's the frost and pipe stat ?🙂

Not my house who cares. 😉

 

[Whn1]

flue's not sealed

Its only a route for possible carbon monoxide rentry, what's the big deal?

 

[Whn1]

Did you use a level on the dhw drawoff or is it my computer screen....Ive learned a valuble lesson over the last few days, Never ever post pictures too you lot haha. well done whn1. brave lad :wink5:

I did, it's the rest of the stuff that's wonky...

 

[Whn1]

You will regret the day you post a picture here !

That day has now come...

 

[SafeGasInstall]

Told you ! Go back repipe and come back here ..... Don't worry you can always get a plying book from Amazon and start reading it ..... Pmsl 🙂