Hi
My basin waste became blocked and so I unscrewed the McAlpine u bend , when I went to put it back I found it was leaking from the top of the ubend near the sink . As the seal was a bit worn I bought a whole new McAlpine identical replacement ubend from screwfix but it has made no difference...
Morning All
I have a Megaflo unvented cylinder . Water had been dripping into the tundish so I tried to recharge the air gap, but when I went to turn the pressure relief valve it would not turn at all, as it usually would. My shower has been dripping in the bathroom next door , could in anyway...
Hi All
Please see attached photos. Does anyone know if the HIVE app and thermostat and control would work with this oil boiler plse? The thermostat control ( Honeywell) is restrictive as you have little options as to when you can have boiler on and off. It's my elderly father's boiler and I...
as this is very similar do you think I could try a box spanner as in vid ?
i think builder who installed shower must have kept tool to remove the pistons as I don’t have this either
there was nothing wrong with it before!, it only started dripping after Thames Water dug up the road and installed meters ! I was left with two dripping showers ! now this carry on... because Bristan sent wrong instructions and sent me off on wild goose chase " oh you can just clean it taking...
https://www.plumbers-mate-sales.co.uk/bristan-plastic-thermostatic-shower-cartridge-00622415-5842-p.asp
this valve is plastic but yours wasnt no idea why
what sort of grips? , i can buy tomorrow but i have some pliers ?? shall i just pull it out gripping threaded part? if i can... .... if i replace the cartridge will it stop the dripping/ water running out (more than dripping now) when i turn on shower !, unless i turn water off , but need on...
I see thanks , I asked bristan to come out but they said their engineers very booked up .... follow these wrong instructions ! 😡
dont know what on earth to do now
As for the controls eg why it’s dripping the left and right brass caps with the two holes in eg holding the valves in that stop the flow
I know I did not assemble it properly in video I was just trying to work out why it wont turn off when it is properly assembled
Really annoying me now , Bristan sent wrong instructions multiple times ! only spent all day on this and still no luck....
turned water off outside but no luck cant budge / pull out cartridge
im assuming this is the replacement /what it looks like ? as is plastic...