Install the app
How to install the app on iOS

Follow along with the video below to see how to install our site as a web app on your home screen.

Note: This feature may not be available in some browsers.

Recent content by Chester

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

  1. C

    SANIFLO discharge query

    Yeah it's not right, it'll block again eventually because it's let out.. can guarantee the kitchen sink is what's properly blocked it before mind you, always the fat 😭
  2. C

    SANIFLO discharge query

    Just want to add I branched in on a Y so slightly better flow not a tee
  3. C

    SANIFLO discharge query

    Thanks for the reply, against this advice I ended up teeing into the 2inch 🤪 as time was of the essence, I called Saniflo Technical and whilst he said the ideal scenario is on its own run you can as long as you (me) thinks the run can handle full flow, it was OK, kitchen sink doesn't gurgle...
  4. C

    SANIFLO discharge query

    Hi guys question about saniflos 💩 I'm working at a property that the entire place was fed off a sani, that's packed up, blocked the line entirely and they've urgently had to get me to replace and make some changes, initially I was going to install a sanivite for the kitchen sink separately...
  5. C

    Gully patio'd over in use

    Update, pipe on right is compromised, failed pressure test, inspection with camera can see a joint directly where the tiles begin to sound 'hollow', upsized left pipe and temp fix running everything through the 1¼ under basin as it's under a tiled floor so not an easy fix.
  6. C

    Gully patio'd over in use

    Hi guys not sure anyone has encountered this before but I have a job where the inside wall has been getting a little damp, there was a step up to the door that I think wasn't helping due to dpc but that was removed to take a closer look and it revealed 2 waste water pipes going into the patio...
  7. C

    Flats bathrooms fed by tank?

    Hi guys I did a job today in a block of flats, fairly old place, plumbing was all a bit ropey in this particular flat. The job was to change an electric shower over, I changed it, didn't work.. noticed the water pressure was a bit pants.. I could stop it with my finger on the basin.. thought...
  8. C

    Programmer fault/wireless stat wiring?

    Thanks, the installer had linked a permanent live from the L and N side of the stat to A I believe it was, I don't think it's necessary in this scenario.. however in the manual it says do this on a 2 port but absolutely no mention of programmer's etc. The bit I don't understand in this situation...
  9. C

    Programmer fault/wireless stat wiring?

    I have accessed the wiring centre, there is 240v coming up from the programmer/thermostat in fault state. This might be a silly question but how does an RF stat with a permanent live supply to the receiver not override the programmer on timed? I understand that the receiver is hard wired in and...
  10. C

    Programmer fault/wireless stat wiring?

    They say they're not sure but I suspect it hasn't. Yes i have all kit
  11. C

    Programmer fault/wireless stat wiring?

    Yes it was tested when the programmer was in an off time period, yet in the loft where the wiring centre is unfortunately, the pump was on (wired into the switch lives in wiring centre) and the 2 port was open still..but I will double check again before I make any alterations. Let's just assume...
  12. C

    Programmer fault/wireless stat wiring?

    It remains live regardless of the programmer timings, until they turn the stat down it doesn't stop they say. Although when I was there I set the timings and waited until it clicked off and it did in fact switch off when it was supposed to so I'm led to think the programmer is at fault. I guess...
  13. C

    Programmer fault/wireless stat wiring?

    But the Zone valve brown signalled from the stat is live?
  14. C

    Programmer fault/wireless stat wiring?

    This is what I initially thought it was but it seems to move fine manually, the brown is definitely being signalled to hold it open
  15. C

    Programmer fault/wireless stat wiring?

    Hi guys, I have a fault on a clients heating system whereby the heating will stay on regardless of what the programmer is doing on its timed function, it'll switch off at the programmer (no light) but boiler will stay on until they turn the stat down, I went and looked at it, they said they...
See more

We recommend City Plumbing Supplies, BES, and Plumbing Superstore for all plumbing supplies.

Featured Content

Sponsors

Electric Underfloor Heating The Wetroom Store Heating 2 Go Electrical Goods - Electrical Tools - Brand Names Official UK Plumbers Forums Facebook Page Gas Talk Group | Gas Safe Register Plumber Workwear Specialist

Featured Plumbing Threads

VividPromotion Workwear
Top Bottom
Back