Hello
I'm new to the forum and to the plumbing world but I start my course in September and in the meantime I though it would be a good idea to start accumulating the tools of the trade for the future as I'm sure they won't be cheap, so really I just want to know where do you recommend I do my...
Hi
Is the a special tool to tighten and loosen this drain fitted to a bath?
All the screwdrivers I have that are wide and will reach the two slots are to thick to go in them.
Mike
Hi
Boss phoned me today and he asked me to take him a 25mm hole cutter to put in an adaptor to the stack but i was miles away and not finished on my job so when i did get there he said he doesn't need it as he had used another tool to do it.
It was an exisiting hole that he had to make bigger...
I've been told that there is available a tool that removes the Giannoni glands easily a bit like a socket. Never seen one and can't find one on the internet. My mate has one but he made it 25 years ago but I would rather buy one. Any ideas anyone ??
Looking to purchase a battery press tool for various use. Looking at the following:
REMS accu press - looks heavy and bulky compared to the others, but good value (for a press tool!) and easy to come by.
Milwaukee M18 force logic - more expensive but more compact and good warranty.
Gerberit...
This weekend in South of England
How to get here Finding the show by Car The FFX tool show is being held at The Kent Event Centre which is ideally suited for arrival by car. It is located on the A249, which is a dual carriageway. From the M20 Motorway, exit the motorway at junction (7)...
Hi guys I'm after a new reseating tool as my cheapo one has finally packed in.
Any recommendations? I overhaul a fair amount of taps as part of a maintenance contract so don't mind spending a bit extra.
I was thinking of having a permanent set up in the back of the van for recharging batteries as I drive, using the power from the vehicle, so there will be no messing about or forgetting to put the battery on charge overnight Anyone got anything set up like this? Or any advice?
I know this...
I had to change a 3/4 inch rad valve today and the tail had 2 grooves instead of a hex key.
Is there a specific tool for these tails as I had to borrow another guys makeshift tool to get it out
Cheers
Picked one up at lunchtime today, bargain.
http://www.diy.com/departments/stanley-250mm-tool-bag/141666_BQ.prd
http://www.NoLinkingToThis/p/stanley-fatmax-hard-base-tool-bag/76628
This looks so handy, wondering if it would fit through uk full way isolation valves. But still that pesky bit of 15mm with the water in it? you know the one? haha
ye old yanks use imperial pipe, hmmm
https://www.youtube.com/watch?v=_oPE5xDfR3A
Just bought this ......
It's milwaukiee so it's rubbish
[emoji38][emoji38][emoji38][emoji38][emoji38][emoji38][emoji38]
Oh and the price
They had 10. Call and buy direct
I've had a look on here but can't see a bargain tool thread.
bosch LBOXX 5 for £121
8 piece core set £39.99
Bosch pro multi tool £79.99
bosch pro 18v 3ah with lboxx £79.99
please keep adding more
Friends
Anyone know of any sites with tool sales?
As you know mine got thieved so still replacing,
I've been looking but no luck with anything cheap thus far.
Cheers
Rct