I have a problem with 2 toilets fitted to a wall with the cisterns in the wall. I would like to replace them with standard toilets but the waste pipe seems too high (around 60mm above a standard toilet) and I don't have enough slope on the waste pipe to lower it. Are there any toilets out there...
I have a Vitra reduced height 75/108cm frame to fit a Vitra wall hung WC to. I also have a 550 x 210mm cabinet to fit around it.
I have a few questions:-
1. To ensure the cabinet fits I have to fit the frame flush to the back wall and have had to remove the rear cross-member of the cabinet to...
If have the below shower/bath tap mixer to fit. The finish wall won't be tiles but plastic sheeting. That isn't too strong. So I want a way of fixing the shower to the wall before it's sheeted. Do I use the offset connectors supplied and a back plate elbow or buy shower mounting kit? It's on to...
Hi
Our plumber has just fitted a wall hung toilet frame. However he found that the frame to too tall and came above the window ledge. To make the frame fit, he has sawn off a horizontal bar at the top of the frame. The horizontal bar removed were where the brackets to fix the frame to the...
Am looking to fit a wall hung toilet in the next few weeks. I am completely confused by which frame to buy! Am I right to stick to something like grohe or gerberit...
Hi everyone, new to this forum and would greatly appreciate any advice.
We installed a walk in shower with a false wall to conceal the shower, toilet and wall hung sink pipes. There was a slow leak which led to a lot of mould growth. We opened the shower pockets and cleaned pretty much all the...
Hi - new to the forum, thanks in advance for any advice.
I have a Greenstar 30cdi boiler with currently a boiler mounted FW100 weather compensation controller. I would like to wall mount the FW100 to replace the old Honeywell T6360-1028 mechanical thermostat which is currently in the hallway...
The pan is screwed down using a Screwfix/Rawlplug fitting kit and I have sealed the pan to the wall tiles.
My question is: Do I need to also seal the pan to the floor tiles?
I think it looks neater without silicon to the floor tiles and it would create a sealed void should the cistern inlet...
Hi everyone, I’m a bit paranoid about asbestos, and I’m living in this apartment - looks to be around mid80s - with a texture on most of the walls (although not ceilings) and the built-in cupboards and shelves. It’s mostly in good condition, but there are a few damaged bits. Do you reckon it’s a...
Need advice around these clicking sounds. I posted last week, but I didn’t get much luck. This I have recorded the sounds. The sound appear to be around my toilet, but I don’t think the toilet is the issue but something behind toilet - in the wall and probably a pipe.
Hope you can help me...
I have a very important customer that wants a Toto wall hung toilet. I would like to use a Geberit. The unique part is the customer wants a remote flush button and not the carrier access panel in the bathroom. My supplier states that the carrier can be hung rotated 180 so the access and...
We have a plasterer coming this week and the radiators need to come off! A DIY friend came round and removed all but 1 radiator as he wasnt sure what to do as the thermastat on one end has been broken??? HELP if we turn the valve off at the other end will this do the job so we can just remove it...
Hello,
When a Danfoss RAS C2 10 mm TRV is open to its maximum setting is this the same or almost the same as having a rad with no TRV ?.
And if it is open to this maximum and left open can a wall thermostat be placed in the same room and work effectively ?.
I'm in a property with a newly fitted...
Just bought a Crosswater Fusion 3 hole wall mounted bath tap. Can't for the life of me figure how I can fit and secure it.
According to the instructions there are two screwed flanges on the body of the tap that hold the tap. Sounds reasonable except that the length of the tap and hence max...
Hi all,
The radiator has fallen off a wall on one side - the screw into the wall seems to have been into the mortar rather than the brick and come out (see Pic1).
Attached are the ends either side of the radiator - my question is, will I be able to isolate and drain this radiator myself? If...
I'm going to need a new boiler before too long, it's been in there for a while and really showing it's age.
My current boiler is 55k BTu and does only the central heating. (I also have a multipoint boiler that does my hot water. I KNOW I could have a combi, but I like it this way). The CH...
We are renovating our house and after a lot of playing around I have worked out the best floorplan for upstairs. It means the only place I can fit our ensuite is in the middle of the house, the toilet will be 2.7m from the main soil stack in the family bathroom. It is in a straight line and I...