Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

View the thread, titled "Back Boiler fitting new radiators." which is posted in Boiler Advice Forum on UK Plumbers Forums.

Status
Not open for further replies.
O

ozzy

Hi

I've been to look at a job to fit 4 new radiators and connect to an existing back boiler.

The flow and return pipes from the back boiler have been hacked off flush with the wall. The open fire has been regularly used since then with no water in the boiler.

I would have thought that the back boiler would now be no good due to the fact of the open fire being used with no water in the boiler, am I correct?
 
not worth the hassle and doesnt really work for eco folks out there either, would you be putting on a pump etc
 
I'm guessing I would have to fit a pump. I'm thinking I will hand this one on lol as I'm not a heating engineer
 
It sounds like a no go situation. Back boiler is likely to be damaged, you will require high temperature Feed and expansion, a gravity circuit and a pumped circuit and it won't even be efficient. If I were going down the route of solid fuel water heating, I would put a wood burning stove in and have stored hot water and radiators. Must be done by a HETAS registered engineer.
 
Thanks Reg Man. I think you are definitely right on the no go. They only want it for the heating. they have a unvented cylinder in the roof and electric rads. they said the electric rads are costing £60 aweek. My guess is it was probably taken out because It wasn't working or leaking.
 
It sounds like a no go situation. Back boiler is likely to be damaged, you will require high temperature Feed and expansion, a gravity circuit and a pumped circuit and it won't even be efficient. If I were going down the route of solid fuel water heating, I would put a wood burning stove in and have stored hot water and radiators. Must be done by a HETAS registered engineer.

i thought heatas was voluntary rather than compulsory
 
Not compulsory but you will need it signing off so may as we'll get somebody who can self with either heras or another body.
 
I'm not going to get involved its got disaster written all over it. The pipes that are cut off at the wall rather part cut then bent up and down until they broke off, you would have to cut back into the side of the fire place to find a bit of good pipe if any to connect on to. so I'm going to pass on this won. thanks for all your advice
 
No chance would I be touching that! They probably just think ohhhh radiators on wether wall heated by that thing there that will be good without realising tanks, pumps etc etc.

suggest a combi and they can start saving
 
They should not be using the open fire unless the back boiler has been decommissioned properly. Removed / Drilled / Filled with sand.
 
I don't no if it is been disconnected or not, there not long moved in there. they have a unvented cylinder in the roof and electric rads but I'm not getting involved
Thanks all
 
If theres open ends on the back boiler where the pipeworks been cut off and the fires still operating you should tell them its not safe, they should be sealed. Id advise a gsr to come and take a look for there safety.
 
Status
Not open for further replies.

Official Sponsors of Plumbers Talk

Reply to the thread, titled "Back Boiler fitting new radiators." which is posted in Boiler Advice Forum on Plumbers Forums.

We recommend City Plumbing Supplies, BES, and Plumbing Superstore for all plumbing supplies.

Weekly or Monthly Email Digest

Back
Top