Hi there was wondering if anyone had some advise regarding controls.
Just been to look at a boiler swap. The current system is an s plan plus, there's a three channel prog in the kitchen. First and ground floor zones, with hot water provided by an unvented cylinder in the loft next to boiler.
The customer wants to upgrade the current heating stats which will also need moving. Now to save to much disruption I would normally fit RF. The problem I think I'm gonna have is I may have to keep these hard wired as i'll have to keep the cylinder like this.
My question is... Does anyone know if there's any manufacturers making programmers where channels can be hard wired aswell as wireless? Or could I wire a receiver through both heating channels on the current prog?
Hope this is clear.
Just been to look at a boiler swap. The current system is an s plan plus, there's a three channel prog in the kitchen. First and ground floor zones, with hot water provided by an unvented cylinder in the loft next to boiler.
The customer wants to upgrade the current heating stats which will also need moving. Now to save to much disruption I would normally fit RF. The problem I think I'm gonna have is I may have to keep these hard wired as i'll have to keep the cylinder like this.
My question is... Does anyone know if there's any manufacturers making programmers where channels can be hard wired aswell as wireless? Or could I wire a receiver through both heating channels on the current prog?
Hope this is clear.
Last edited:
